Abstract：Transient rotating speed signal of centrifugal pump cavitation process was acquired through installing shaft encoder, and its characteristics and law under different levels of cavitation were further explored by means of time domain and frequency domain analysis. The analysis results showed that when cavitation just occurs in centrifugal pump, its rotating speed has the largest variation range, and fluctuation degree of rotating speed measured with standard deviation is also the largest, and the fluctuation degree of rotating speed under severe cavitation is higher than that without cavitation; in frequency domain, the natural frequency of the rotating speed of the centrifugal pump-motor system used in tests is 2.9 Hz; under cavitation condition, the main frequency of the pump rotating speed is also the shaft frequency, it does not change with the variation of flow rate and cavitation degree, but under the same flow rate, the amplitude of the main frequency is the highest during initial cavitation, followed by that during severe cavitation, and that is the minimum without cavitation; under different flow rates, the amplitude of the main frequency during initial cavitation firstly increases and then decreases with increase in flow rate, it reaches the maximum under the designed flow rate; in time-frequency domain, rotating speed characteristics are analyzed with wavelet analysis, its energy mainly concentrates in the range of 39-46.9 Hz under cavitation, and the rotating speed energy is the largest during initial cavitation.
骆寅，董健，韩岳江，袁建平. 离心泵空化下的转速瞬变特性试验研究[J]. 振动与冲击, 2021, 40(1): 23-28.
LUO Yin, DONG Jian, HAN Yuejiang, YUAN Jianping. Tests for rotating speed transient characteristics of centrifugal pump under cavitation. JOURNAL OF VIBRATION AND SHOCK, 2021, 40(1): 23-28.
[1] Huang X, Yuan S, Zhang J, et al. Effects of blade wrap angle on performance of high specific speed centrifugal pump[J]. Journal of Drainage and Irrigation Machinery Engineering, 2016.
[2] 尹江南, 袁寿其, 骆寅, et al. 离心泵叶轮磨损破坏程度下的振动特性分析[J]. 振动与冲击, 2019, 38(01):52-57+80.
Yin Jiangnan, Yuan Shouqi, Luo Yin, et al. Analysis of vibration characteristics of centrifugal pump impeller under wear and tear [J]. Journal of Vibration and Shock, 2019, 38(01): 52-57+80.
[3] 袁建平, 侯敬生, 付燕霞, et al. 离心泵回流漩涡空化的非定常特性研究[J].振动与冲击, 2018(16):24-30.
Yuan Jianping, Hou Jingsheng, Fu Yanxia, et al. Unsteady characteristics of recirculating vortex cavitation in centrifugal pumps[J]. Journal of Vibration and Shock, 2018(16):24-30.
[4] 牟介刚, 陈莹, 谷云庆, et al. 不同空化程度下离心泵流固耦合特性研究[J].振动与冲击, 2016(23).
Geng Jiegang, Chen Ying, Gu Yunqing, et al. Study on fluid-solid coupling characteristics of centrifugal pump under different cavitation degrees[J]. Journal of Vibration and Shock, 2016(23).
[5] M. Cudina, 2002, Noise as indicator of cavitation in a
centrifugal pump, Acoustical Physics 49, No 4. [6] Black H. F. Effects of hydraulic forces in annular pressure seals on the vibrations of centrifugal pump rotors[J]. Journal of Mechanical Engineering Science, 1969,11(2):206-213.
[6] M. Cudina, 2003, Noise as indicator of cavitation in a centrifugal pump, Journal of Mechanical system and signal processing 17(6), 1335-1347.
[7] F. Gu, P.J. Jacob and A. D. Ball 1999, Non-parametric
models in the monitoring of engine performance and
condition – Part 2: non-intrusive estimation of diesel
engine cylinder pressure and its use in fault detection, Mech E. Proc Instn Mech Engrs, Part D, Vol 213, pp. 135-143.
[8] M. Elhaj, F. Gu, A. Ball, J. T. Wright, A study of instantaneous angular speed of a compressor for condition monitoring, COMADEM 2003, Sweden.
[9] B. Liang, 2000, Condition monitoring of three-phase induction motors, PhD thesis, University of Manchester.
[10] A. Ben Sasi, B. Payne, A. York, F. Gu, A. D. Ball,condition monitoring of electric motors using instantaneous angular speed, MARCON 2001, Gatlinburg, Tennesse, USA.
[11] Feldman, M. and Seibold, S. 1999, Damage Diagnosis of Rotors: Application of Hilbert Transform and Multiphysics Testing, Journal of Vibration and Control, Vol 5, pp 421-442.
[12] Tsukamoto H., Yoneda H., Sagara K. The response of a centrifugal pump to fluctuating rotational speed[J]. Journal of fluids engineering, 1995,117(3):479-484.
[13] Lei T , Shan Z B , Liang C S , et al. Numerical simulation of unsteady cavitation flow in a centrifugal pump at off-design conditions[J]. Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 2014, 228(11):1994-2006.
[14] Guo X M, Zhu Z C , Shi G P , et al. Effects of rotational speeds on the performance of a centrifugal pump with a variable-pitch inducer[J]. Journal of Hydrodynamics, Series B, 2017, 29(5).
[15] Tan L , Zhu B , Wang Y , et al. Numerical study on characteristics of unsteady flow in a centrifugal pump volute at partial load condition[J]. Engineering Computations, 2015, 32(6):1549-1566.
[16] 郭义航, 袁寿其, 骆寅, et al. 基于试验的离心泵转速瞬变特性研究[J]. 振动与冲击, 2018(10):187-193.
Guo Yihang, Yuan Shouqi, Luo Yin, et al. Experimental study on transient characteristics of centrifugal pump speed[J]. Journal of Vibration and Shock, 2018(10): 187-193.
[17] Hao Y , Tan L . Symmetrical and unsymmetrical tip clearances on cavitation performance and radial force of a mixed flow pump as turbine at pump mode[J]. Renewable Energy, 2018, 127:368-376.
[18] A. Wolfram, D. Fussel, T. Brune and R. Iserman, 2001, Component-based multi-model approach for fault detection and diagnosis of a centrifugal pump, American Control Conference, 2001, Proceeding of the 2001, Vol. 6, pp4443-4448.
[19] I. I. Kutbi, 1991, Evaluation of centrifugal pump
performance in nuclear power plants, Ann. Nucl. Energy, Vol 18, No 11, pp. 629-654.
[20] Rizwan-Uddin,1994, Steady-state characteristics based model for centrifugal pump transient analysis, Ann. Nucl.
Energy, Vol.21, No.5, pp. 321-324.
[21] Hagiwara N, Suzuki Y, Murase H. A method of improving the resolution and accuracy of rotary encoders using a code compensation technique[J]. IEEE Transactions on Instrumentation and Measurement, 1992, 41(1):98-101.
[22] Wang Z, Li G, Sun Y, et al. Effect of erroneous position measurements in vector-controlled doubly fed induction generator[J]. IEEE Transactions on Energy Conversion, 2010, 25(1):59-69.
[23] 苏永生, 王永生, 段向阳,等. 离心泵空化试验研究[J]. 农业机械学报, 2010, 41(3):77-80.
Su Yongsheng, Wang Yongsheng, Duan Xiangyang,et al.Cavitation Test of Centrifugal Pumps[J]. Transactions of the Chinese Society of Agricultural Machinery, 2010, 41(3): 77-80.
[24] 王勇[1], 赵宇琪[1], 董亮[1], et al. 基于流声耦合法的超低比转数离心泵空化特性研究[J]. 农业机械学报, 2017(12):114-123.
Wang Yong [1], Zhao Yuqi [1], Dong Liang [1], et al. Study on Cavitation Characteristics of Ultra-low Specific Speed Centrifugal Pump Based on Flow Acoustic Coupling Method[J]. Transactions of the Chinese Society of Agricultural Machinery, 2017(12): 114-123.
