基于频变阻尼特性的四参数隔振系统建模与参数分析

摘要
图/表
参考文献(30)
相关文章 (15)

全文: PDF (1514 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要随着航天技术的快速发展，航天器中的有效任务载荷对隔振器的可靠性、稳定性要求不断越高。为了解决传统被动隔振器中低频与高频隔振性能之间的矛盾，亟需一种能够实现低频大阻尼、高频小阻尼的频变隔振系统。因此，基于现有的三参数模型，提出一种具有频变阻尼特性的四参数隔振系统；并通过归一化参数，建立系统数学模型，分析各参数对系统性能的影响。针对建立的理论计算模型，利用Simulink进行仿真验证，相较于被动隔振系统，四参数系统能够将7Hz固有频率处的传递率幅值降低28.85dB，证明低频大阻尼效果显著；同时，采用100Hz正弦信号激励时，时域幅值衰减率达99.5%，证明高频小阻尼作用凸显，从而验证了四参数系统具有频变阻尼特性，即低共振峰值和良好的高频隔振性能。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	蒲华燕
	何文元
	孙翊
	丁基恒
	罗均
	谢少荣
	彭艳
	王敏

关键词 ：四参数系统, 频变阻尼, 隔振, 归一化参数, 参数优化

Abstract：With the rapid development of aerospace technology, the effective mission load in spacecraft has continuously higher requirements for reliability and stability of vibration isolators. In order to solve contradictions between low-frequency and high-frequency isolation performance in traditional passive isolators, a frequency-dependent isolation system that can achieve large damping at low frequencies and small damping at high frequencies is urgently needed. A four-parameter isolation system with frequency-dependent damping characteristics was proposed based on existing three-parameter model. The mathematical model was established and influences of each parameter on system performance was analyzed. For established theoretical model, Simulink was used for simulation verification. Compared with the passive isolation system, it was shown that the four-parameter system can reduce the transmission rate amplitude at 7Hz natural frequency by 28.85dB; using 100Hz sine signal excitation, the time-domain amplitude attenuation rate reaches 99.5%; the four-parameter system has low resonance peak and good high-frequency isolation performance.

Key words： four-parameter system frequency-dependent damping vibration isolation normalized parameters parameter optimization

收稿日期: 2020-08-18 出版日期: 2021-12-28

引用本文:

蒲华燕，何文元，孙翊，丁基恒，罗均，谢少荣，彭艳，王敏. 基于频变阻尼特性的四参数隔振系统建模与参数分析[J]. 振动与冲击, 2021, 40(24): 128-135.
PU Huayan，HE Wenyuan，SUN Yi，DING Jiheng，LUO Jun，XIE Shaorong，PENG Yan，WANG Min. Modeling and parameter analysis of a four-parameter isolation system based on frequency-dependent damping characteristics. JOURNAL OF VIBRATION AND SHOCK, 2021, 40(24): 128-135.

链接本文:

http://jvs.sjtu.edu.cn/CN/ 或 http://jvs.sjtu.edu.cn/CN/Y2021/V40/I24/128

[1] Rivin E I. Passive vibration isolation[J], Applied Mechanics Reviews, 2003, 57(6): B31–B32.
[2] Kamesh D, Pandiyan R, Ghosal A. Passive vibration isolation of reaction wheel disturbances using a low frequency flexible space platform[J], Journal of Sound and Vibration, 2011, 331(6): 1310–1330.
[3] Kim J, Jeon Y, Um S, et al. A Novel Passive Quasi-Zero Stiffness Isolator for Ultra-Precision Measurement Systems[J]. International Journal of Precision Engineering and Manufacturing, 2019, 20(9): 1573-1580.
[4] Hu F, Jing X. A 6-DOF passive vibration isolator based on Stewart structure with X-shaped legs[J]. Nonlinear Dynamics, 2018.
[5] Cunningham D, Davis P. A multiaxis passive isolation system for a magnetic bearing reaction wheel[J], Advances in the Astronautical Sciences, 1993, 95(454).
[6] Davis P, Cunningham D, Harrell J. Advanced 1.5 Hz passive viscous isolation system[C], 35th Structures, Structural Dynamics, and Materials Conference.Hilton Head:AIAA, 1994.
[7] Kim D-K. Micro-vibration model and parameter estimation method of a reaction wheel assembly[J]. Journal of Sound and Vibration, 2014, 333(18): 4214–4231.
[8] Zhang Z, Aglietti G S, Zhou W, et al. Microvibrations induced by a cantilevered wheel assembly with a soft-suspension system[J]. AIAA Journal, 2011, 49(5): 1067-1079.
[9] Liu C, Jing X, Daley S, et al. Recent advances in micro-vibration isolation[J]. Mechanical Systems and Signal Processing, 2015: 55-80.
[10] Kawak B J. Development of a low-cost, low micro-vibration CMG for small agile satellite applications[J]. Acta Astronautica, 2017: 113-122.
[11] Qin C, Xu Z, Xia M, et al. Design and optimization of the micro-vibration isolation system for large space telescope[J], Journal of Sound and Vibration, 2020, 482.
[12] Chen S, Xuan M, Xin J, et al. Design and experiment of dual micro-vibration isolation system for optical satellite flywheel[J]. International Journal of Mechanical Sciences, 2020, 179:105592.
[13] 邓峰岩, 和兴锁, 张娟, 等. 微振动对空间实验室微重力环境的影响研究[J]. 振动与冲击, 2005(03): 103-107+138.
Deng Fengyan, He Xingsuo, Zhang Juan, et al. Research on the Influence of Microvibration on the Microgravity Environment of Space Laboratory[J]. Journal of Vibration and Shock, 2005(03): 103-107+138.
[14] Stabile A, Aglietti G S, Richardson G, et al.A 2-collinear-DoF strut with embedded negative-resistance electromagnetic shunt dampers for spacecraft micro-vibration[J], Smart Materials and Structures, 2017, 26(4).
[15] Stabile A, Aglietti G S, Richardson G, et al. Design and verification of a negative resistance electromagnetic shunt damper for spacecraft micro-vibration[J], Journal of Sound and Vibration, 2017, 386: 38–49.
[16] Wei Z, Li D, Luo Q, et al. Modeling and analysis of a flywheel microvibration isolation system for spacecrafts[J]. Advances in Space Research, 2015, 55(2): 761-777.
[17] Preda V, Cieslak J, Henry D, et al. Microvibration attenuation based on H∞/LPV theory for high stability space missions[J], Journal of Physics: Conference Series, 2015, 659(1).
[18] Kamesh D, Pandiyan R, Ghosal A. Modeling, design and analysis of low frequency platform for attenuating micro-vibration in spacecraft[J], Journal of Sound and Vibration, 2010, 329(17): 3431–3450.
[19] Karnopp D. Active and Semi-Active Vibration Isolation[J]. Journal of Mechanical Design, 1995: 177-185.
[20] Zuo L, Slotine J E. Robust vibration isolation via frequency-shaped sliding control and modal decomposition[J]. Journal of Sound and Vibration, 2005, 285(4): 1123-1149.
[21]   Liu Likun, Zheng Gangtie, Huang Wenhu, et al. Study of liquid viscosity dampers in octo-strut platform for whole-spacecraft vibration isolation[J]. Acta Astronautica, 2006, 58(10): 515-522.
[22] Brennan M J, Carrella A, Waters T P, et al. On the dynamic behaviour of a mass supported by a parallel combination of a spring and an elastically connected damper[J]. Journal of Sound and Vibration, 2008, 309(3): 823-837.
[23] 王超新, 孙靖雅, 张志谊, 等. 最优阻尼三参数隔振器设计和试验[J].机械工程学报, 2015, 51(15): 90-96.
Wang Chaoxin, Sun Jingya, Zhang Zhiyi, et al. Design and experiment of a three-parameter vibration isolator with optimal damping [J]. Journal of Mechanical Engineering, 2015, 51(15): 90-96.
[24]   焦小磊, 赵阳, 马文来, 等. 三参数隔振系统归一化模型及参数优化[J]. 振动与冲击, 2018, 37(21): 204-212.
Jiao Xiaolei, Zhao Yang, Ma Wenlai, et al. Normalized model and parameter optimization of a three-parameter isolation system[J]. Journal of Vibration and Shock, 2018, 37(21): 204-212.
[25] Zhang Yao, Zhang Jingrui, Xu Shijie, et al. Parameters design of vibration isolation platform for control moment gyroscopes[J]. Acta Astronautica, 2012, 81(2): 645-659.
[26] 张尧, 张景瑞. 隔振平台对姿态控制系统影响分析及参数选择[J]. 宇航学报, 2013, 34(05): 657-664.
Zhang Yao, Zhang Jingrui. Analysis of influence of vibration isolation platform on attitude control system and its parameter selection[J], Yuhang Xuebao/Journal of Astronautics, 2013, 34(05): 657-664.
[27] 王杰, 赵寿根, 吴大方, 等. 微振动隔振器动态阻尼系数的测试方法[J]. 航空学报, 2014, 35(02): 454-460.
Wang Jie, Zhao Shougen, Wu Dafang, et al. A test method of dynamic damping coefficient of micro-vibration isolators[J]. Acta Aeronautica et Astronautica Sinica, 2014, 35(02): 454-460.
[28] 王杰, 赵寿根, 吴大方, 等. 隔振器动力学参数的测试方法研究[J]. 振动工程学报, 2014, 27(06): 885-892.
Wang Jie, Zhao Shougen, Wu Dafang, et al. Research on testing method of dynamic parameters of vibration isolators[J]. Journal of Vibration Engineering, 2014, 27(06): 885-892.
[29]  Silva L D H, Gonalves P J P, Wagg D. On the dynamic behavior of the Zener model with nonlinear stiffness for harmonic vibration isolation[J]. Mechanical Systems and Signal Processing, 2018, 112, 343-358.
[30]   Wang X, Yao H, Zheng G, et al. Enhancing the isolation performance by a nonlinear secondary spring in the Zener model[J]. Nonlinear Dynamics, 2017, 87(4): 2483-2495.