Analysis of suspension cable force of large-span steel tube concrete tied arch bridge
WANG Xianyu1,2, WANG Xingwu2, LIANG Xiao3, ZHOU Min4, DU Yongfeng1
1.Institute of Earthquake Prevention and Disaster Mitigation, Lanzhou University of Technology, Lanzhou 730030, China;
2.Gansu Transportation Planning, Survey and Design Institute Co., Ltd., Lanzhou 730030, China;
3.School of Civil Engineering, Southwest Jiaotong University, Chengdu 610031, China;
4.Neijiang Normal University, Neijiang 641000, China
Abstract：Aiming at the problem of hanger forces of long-span concrete-filled steel tube tied arch bridges, the solution to this problem should be based on the derivation of the cable force formulas with different constraints which is based on the energy method, combined with engineering examples. System analysis and corresponding optimization suggestions should also be given in three aspects: Firstly, the optimization of the cable force during the design phase of the suspender. Secondly, the actual measurement of the cable force during the bridge formation. Thirdly, the influence of the bending stiffness of the cable force in the operation stage. The analysis results show that the cable force formula derived by the energy method is feasible. After optimization in the design phase, the cable force of the boom is more uniform and the displacement of the tie beam is more reasonable. When the frequency method is used to test the cable force of the boom, the test point should be placed At L/6~L/4 of the boom, which should be stayed as far away from the two ends of the boom as possible and avoid placing it at the modal node of the formation to reduce the impact of the low-frequency signal at the end on the fundamental frequency and the phenomenon of "leakage". There is a difference between the calculated flexural stiffness of the suspender and the actual flexural stiffness in the operation stage, which leads to the great difference between the measured cable force and the actual structural cable force. Aiming at this problem, the method of measuring the actual flexural stiffness of the suspender in the completion stage is proposed, which effectively reduces the measurement error of cable force, and provides calculation basis for accurate measurement of cable force in bridge operation stage.
王宪玉1,2，王兴武2，梁孝3，周敏4，杜永峰1. 大跨度钢管混凝土系杆拱桥吊杆索力分析[J]. 振动与冲击, 2023, 42(17): 306-313.
WANG Xianyu1,2, WANG Xingwu2, LIANG Xiao3, ZHOU Min4, DU Yongfeng1. Analysis of suspension cable force of large-span steel tube concrete tied arch bridge. JOURNAL OF VIBRATION AND SHOCK, 2023, 42(17): 306-313.
[1] 孙志伟,邬晓光.基于应力平衡法的系杆拱桥吊杆力的优化[J].武汉大学学报(工学版),2017,50(05):704-707+713.
Sun Zhi wei, Wu Xiaoguang. Optimization of Suspender Force of Tied Arch Bridge Based on stress balance method [J]. Journal of Wuhan University (Engineering Edition), 2017,50 (05): 704-707 + 713
[2] 张锦凯. 钢箱系杆拱桥柔性吊杆的参数识别及索力优化[D].长安大学,2017.
Zhang Jinkai. Parameter identification and cable force optimization of flexible suspender of steel box tied arch bridge [D]. Chang'an University, 2017
[3] 戴杰,秦凤江,狄谨,陈永瑞.斜拉桥成桥索力优化方法研究综述[J].中国公路学报,2019,32(05):17-37.
Dai Jie, Qin fengjiang, di Jin, Chen Yongrui. A review of cable-stayed bridge cable force optimization method [J]. Chinese Journal of highway, 2019,32 (05): 17-37
[4] 王祥国,邓博,杨孟刚.考虑施工阶段的高铁系杆拱桥吊杆张拉优化研究[J].铁道科学与工程学报,2020,17(04):808-814.
Wang Xiang guo, Deng Bo, Yang menggang. Study on Suspender Tension Optimization of high speed railway tied arch bridge considering construction stage [J]. Journal of Railway Science and engineering, 2020,17 (04): 808-814
[5] 李睿,李晓章,郑祥隆,周亦唐.粒子群算法在基于频率的两端固结吊杆索力识别中的应用[J].振动与冲击,2018,37(09):
196-201
Li Rui, Li Xiaozhang, Zheng Xianglong, Zhou Yitang. Application of particle swarm optimization algorithm in frequency based cable force identification of two end fixed suspenders [J]. Vibration and Impact, 2018,37 (09): 196-201.
[6] Tension Identification of Suspenders with Supplemental Dampers for Through and Half-Through Arch Bridges under Construction[J] . Deshan Shan,Y. H. Chai,Xiaohang Zhou
,Inamullah Khan. Journal of Structural Engineering . 2019 (3)
[7] 赵雪峰,丁言兵,韩瑞聪,喻言,胡伟通,官泉华,毛幸全,焦栋,李明楚,欧进萍.基于智能手机的无线索力测量方法[J].振动与冲击,2016,35(18):147-151
Zhao Xuefeng, Ding Yanbing, Han Ruicong, Yu Yan, Hu Weitong, Guan Quanhua, Mao Xingquan, Jiao Dong, Li Mingchu, Ou Jinping. Measurement Method of Wireless Cable Force Based on Smartphone [J]. Vibration and Shock, 2016, 35 (18): 147-151
[8] 陈鑫,朱劲松,林阳子,官幼平.基于导波多点散射的在役拱桥吊杆腐蚀损伤识别[J].振动与冲击,2021,40(19):295-301.
Chen Xin, Zhu Jinsong, Lin Yangzi, Guan Youping. Corrosion damage identification of suspenders of arch bridges in service based on multi-point scattering of guided waves [J]. Vibration and Impact, 2021,40 (19): 295-301.
[9] 淡丹辉,赵一鸣,陈艳阳.拉索-阻尼器体系振动索力测量法研究[J].振动与冲击,2013,32(16):123-127
Tan Danhui, Zhao Yiming, Chen Yanyang. Research on the measurement method of vibration cable force of cable damper system [J]. Vibration and Impact, 2013, 32 (16): 123-127
[10] R. W. clough. J. penzien. Trans. Wang Guangyuan et al. Structural dynamics [M]. Beijing: Science Press. 1981
[11] 宋一凡,贺拴海,吴小平.固端刚性拉索索力分析能量法[J].西安公路交通大学学报,2001(01):55-57.
Song Yifan, he Shuan Hai, Wu Xiaoping. Energy method for force analysis of rigid stay cables with fixed ends [J]. Journal of Xi'an Highway Jiaotong University, 2001 (01): 55-57
[12] 胡兆同.结构振动与稳定[M].北京:人们交通出版社.2008.
Hu Zhaotong. Structural vibration and stability [M]. Beijing: Renmin Communications Press. 2008
[13] 傅金龙,黄天立.刚性系杆拱桥成桥吊杆索力优化方法的适用性研究[J].铁道科学与工程学报,2014,11(04):6-13.
Fu Jinlong, Huang Tianli. Applicability study of suspender cable force optimization method for rigid tied arch bridge completion [J]. Journal of Railway Science and engineering, 2014,11 (04): 6-13
[14] 任伟新,胡卫华,林友勤.斜拉索模态试验参数研究[J].实验力学,2005(01):102-108.
Ren Weixin, Hu Weihua, Lin Youqin. Study on modal test parameters of stay cables [J]. Experimental mechanics, 2005 (01): 102-108
[15] 唐盛华,方志,杨索.考虑边界条件的频率法测索力实用公式[J].湖南大学学报(自然科学版),2012,39(08):7-13.
Tang Shenghua, Fang Zhi, Yang Suo. A practical formula for measuring cable force by frequency method considering boundary conditions [J]. Journal of Hunan University (NATURAL SCIENCE EDITION), 2012,39 (08): 7-13
[16] 李素贞,LAPUERTA Enrique Cavero.基于振动测试的张弦结构拉索索力识别[J].振动与冲击,2016,35(23):148-152
Li Suzhen, LAPUERTA Enrique Cavero. Identification of cable force of tension string structure based on vibration test [J]. Vibration and Impact, 2016, 35 (23): 148-152
[17] 吴海军,陈思甜,龚尚龙,许羿,施尚伟.斜拉桥索力测试方法研究[J].重庆交通学院学报,2001(04):23-25+37.
Wu Haijun, Chen Sitian, Gong Shanglong, Xu Yi, Shi Shangwei. Study on cable tension test method of cable stayed bridge [J]. Journal of Chongqing Jiaotong University, 2001 (04): 23-25 + 37
[18] 赵洋,李树山,李晓克.系杆拱桥吊杆索力测试研究[J].工程抗震与加固改造,2011,33(04):56-60.
Zhao Yang, Li Shushan, Li Xiaoke. Test and research on suspender cable force of tied arch bridge [J]. Engineering Earthquake Resistance and Reinforcement, 2011, 33 (04): 56-60
[19] 中华人民共和国 国家质量监督检验检疫总局.斜拉桥热挤聚乙烯高强钢丝拉索技术条件:GB/T 18365-2001[S].中国标准出版社,2001.
General Administration of quality supervision, inspection and Quarantine of the people's Republic of China. Technical conditions for hot extruded polyethylene high strength steel wire stay cables for cable stayed bridges: GB / T 18365-2001 [S]. China Standard Press, 2001
