1.School of Urban Railway Transportation, Shanghai University of Engineering Science, Shanghai 201620, China;
2.School of Mechanical Engineering, Shanghai Institute of Technology, Shanghai 201418, China
Abstract:In order to enable the dynamic absorber to more mitigate reduce the vibration of a rail vehicle body and also to better adapt to the remaining space of the lower part of the vehicle, according to the principle of multiple dynamic absorbers, a rail vehicle with multiple dynamic absorbers was modelled in full consideration of the operation characteristics of the urban rail vehicle.By virtue of the vibration model, a design method for multiple dynamic absorbers of urban rail vehicles was proposed.The influence of passenger capacity and velocity change on the damping performance of multiple dynamic absorbers, was discussed, the limitation of traditional multiple dynamic absorbers was pointed out, and then considering the specialties of frequent changes in the vibration frequency of rail vehicles, an optimization method for the target frequency of the multiple dynamic absorbers was proposed, so as to limit the occurrence of vibration growth.Taking four typical urban track lines as examples, the DVA index as a criterion to evaluate vibration reduction effect, was used to obtain the optimal target frequency of the multiple body dynamic absorbers of each line respectively, and to verify the effectiveness of the optimization method.The results show that with the same additional mass, the multiple dynamic absorbers have better vibration absorption capability than the single dynamic absorber.In practical application, it is a more appropriate choice to install a quadruple dynamic absorber on the vehicle body.The multiple dynamic absorbers can play a good damping effect in the entire speed range, which can effectively avoid the occurrence of vibration growth phenomenon.The target frequency of multiple dynamic absorbers should be adjusted for different lines, and specific lines need to be specified to produce the best damping ability.The study provides a reference to the research and application of multiple dynamic shock absorbers to the vehicle body.
宗志祥1,文永蓬1,尚慧琳2,郭林生1,邹钰1. 城轨车辆车体多重动力吸振器减振方法研究[J]. 振动与冲击, 2020, 39(2): 154-162.
ZONG Zhixiang1,WEN Yongpeng1,SHANG Huilin2,GUO Linsheng1,ZOU Yu1. Design method for multiple dynamic absorbers to reduce the vibration of a urban-rail vehicle body. JOURNAL OF VIBRATION AND SHOCK, 2020, 39(2): 154-162.
[1] 楼梦麟, 李守继. 地铁引起建筑物振动评价研究[J]. 振动与冲击, 2007, 26(8):68-71.
LOU Menglin,LI Shouji. Evaluation of building vibration caused by subway[J]. Journal of Vibration and Shock, 2007,26(8):68-71.
[2] 曾京,邬平波,郝建华. 铁道客车系统的垂向减振分析[J]. 中国铁道科学,2006,27(3):62-67.
ZENG Jing,WU Pingbo,HAO Jianhua. Analysis of vertical vibration reduction of railway passenger car system [J]. China Railway Science,2006,27(3):62-67.
[3] 刘耀宗, 郁殿龙, 赵宏刚,等. 被动式动力吸振技术研究进展[J]. 机械工程学报, 2007, 43(3):14-21.
LIU Yaozong, YU Dianlong, ZHAO Honggang, et al. Rview of passive dynamic vibration absorbers [J]. Chinese Journal of Mechanical Engineering, 2007, 43(3): 14-21.
[4] Tomioka T,Tachikawa S,Akiyama Y. Development of torus-shaped elastic body as a vibration absorber for flexural vibration in railway vehicle carbody and its experimental validation using commuter-type vehicle [J]. 2017,4(1):16-00467.
[5] 周劲松,张伟,孙文静,等. 铁道车辆弹性车体动力吸振器减振分析[J]. 中国铁道科学,2009,30(3):86-90.
ZHOU Jinsong,ZHANG Wei,SUN Wenjing,et al. Vibration reduction analysis of the dynamic vibration absorber on the flexible carbody of railway vehicles [J]. China railway Science,2009,30(3):86-90.
[6] GONG Dao,ZHOU Jinsong,SUN Wenjing. On the resonant vibration of a flexible railway car body and its suppression with a dynamic vibration absorber [J]. Journal of Vibration and Control,2013,19(5),649-657.
[7] 文永蓬,李琼,尚慧琳,等.考虑车轨耦合作用的车体动力吸振器减振性能研究[J]. 振动与冲击, 2016, 35(21):53-62.
WEN Yongpeng,LI Qiong,SHANG Huilin,et al. Study on the performance of dynamic vibration absorber for the car body vibration considering the effects of vehicle-track coupling[J]. Journal of Vibration and Shock,2016,35(21):53-62.
[8] 背户一登.动力吸振器及其应用[M]. 北京:机械工业出版社,2013.
KAZUTO SETO. Dynamic vibration absorber and its application [M]. Beijing:china machine press,2013.
[9] 吴崇健,骆东平,杨叔子,等. 离散分布式动力吸振器的设计及在船舶工程中的应用[J]. 振动工程学报, 1999,12(4):584-589.
WU Chongjian,LUO Dongping,YANG Shuzi,et al. Design of discrete dynamic vibration absorber and its application in marine engineering [J]. Journal of Vibration Engineering,1999 ,12(4):584-589.
[10] TAO T, WANG H, YAO C, et al. Parametric sensitivity analysis on the buffeting control of a long-span triple-tower suspension bridge with MTMD [J]. Applied Sciences, 2017, 7(4):395.
[11] ZHU S, YANG J, CAI C, et al. Application of dynamic vibration absorbers in designing a vibration isolation track at low-frequency domain [J]. Proceedings of the Institution of Mechanical Engineers Part F Journal of Rail & Rapid Transit,2017,231(5):546-557.
[12] 翟婉明. 车辆-轨道耦合动力学[M]. 科学出版社,2015.
ZHAI Wanming. Vehicle-Track coupling Dynamics [M]. Science Press,2015.
[13] 石怀龙, 罗仁, 邬平波,等. 基于动力吸振原理的动车组车下设备悬挂参数设计[J].机械工程学报2014, 50(14):155-161.
SHI Huailong, LUO Ren, WU Pingbo,et al. Suspension parameter designing of equipment for elastic multiple units based on dynamic vibration absorber theory [J].Chinese Journal of Mechanical Engineering,2014,50(14):155-161.
[14] 陈春俊,李华超. 频域采样三角级数法模拟轨道不平顺信号[J]. 铁道学报,2006,28(3):38-42.
CHEN Chun-jun,LI Huachao. Frequency Field Sampling Trigonometric Series Method to Simulate Orbit Uneven Signal [J]. Journal of China Railway Society,2006,28 (3):38-42.
[15] 文永蓬,孙倩,周伟浩等. 轨道车辆车体磁流变弹性体吸振器的建模与仿真[J]. 机械工程学报,2018,54(18):60-65.
WEN Yongpeng, SUN Qian, ZHOU Weihao,et al. Modeling and simulation of vibration absorber for the carbody utilizing magnetorheological elastomers [J]. Chinese Journal of Mechanical Engineering,2018,54(18):60-65.
[16] 文永蓬,尚慧琳,董其炜,等. 城市轨道车辆车轮轮缘磨耗分析[J]. 科技导报,2013,31(26):40-43.
WEN Yongpeng,SHANG Huilin,DONG Qiwei,et al.Analysis on the wear of wheel flange for urban rail vehicle[J]. Science & Technolog Review,2013,31(26) :40-43.