水力冲击内蕴初始裂纹混凝土致裂机理

摘要
图/表
参考文献(15)
相关文章 (15)

全文: PDF (1660 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要为研究水力冲击内蕴初始裂纹混凝土破碎机理，采用光滑粒子流体动力学(SPH)方法建立了水力冲击含竖向裂纹混凝土数值模型，并基于图像处理技术，量化表征了混凝土致裂区破碎规律。研究表明：在初始裂纹弱作用区，水锤效应导致液固接触边界出现剪切断裂，贯通后形成近似“碗状”破碎坑；在初始裂纹强作用区，液固接触边界压剪应力和初始裂纹上部应力集中共同作用引发了初始裂纹上尖端裂纹；“水楔+砼楔”效应与初始裂纹下部应力集中导致了初始裂纹下尖端裂纹；水力冲击激发的应力波在自由边界和初始裂纹反射后相互叠加，引发了锥形裂纹；混凝土破碎度沿射流轴向呈非线性阶跃衰减，表明初始裂纹对混凝土破碎演化有明显阻断及强干扰作用。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	刘佳亮1
	2
	3
	张娣2
	杜书健2
	王海洋2
	3

关键词 ：水力冲击, 混凝土, 初始裂纹, 光滑粒子流体动力学（SPH）, 图像处理技术

Abstract：In order to explore the breaking mechanism of concrete with initial cracks under hydraulic impacting, a numerical model was established based on the smooth particle hydrodynamics (SPH), and the evolution process of concrete crushed in the crack area was quantitatively investigated by using the image processing technology.The results show that at the weak influence zone of an initial crack, the water hammer effect causes shear fracture in concrete on liquid-solid contact boundaries, resulting in a bowl-shaped crushing pit.At the strong influence zone of the initial crack, cracks nearby the upper tip of the initial crack are induced by combined effects of the compression-shear stress on liquid-solid contact boundaries and the stress concentration at the upper zone of the initial crack.Then synergistic actions of the water wedge and concrete wedge effects, combined with the stress concentration at the lower zone of the initial crack produce the cracks nearby the lower tip of the initial crack.Conical cracks are caused by the superimposed stress waves reflecting on free boundaries and on the initial crack.The degree of concrete crushing decreases along the water jet axis direction with different attenuation rate, indicating that the initial crack has significant blocking effect and strong interference action on the evolution of concrete crushing.

Key words： hydraulic impacting concrete initial crack smooth particle hydrodynamics (SPH) image processing technology

收稿日期: 2019-01-08 出版日期: 2020-07-15

引用本文:

刘佳亮1,2,3，张娣2，杜书健2，王海洋2,3. 水力冲击内蕴初始裂纹混凝土致裂机理[J]. 振动与冲击, 2020, 39(14): 130-135.
LIU Jialiang1,2,3,ZHANG Di2,DU Shujian2,WANG Haiyang2,3. Crack formation mechanism of concrete with an initial crack under hydraulic impacting. JOURNAL OF VIBRATION AND SHOCK, 2020, 39(14): 130-135.

链接本文:

http://jvs.sjtu.edu.cn/CN/ 或 http://jvs.sjtu.edu.cn/CN/Y2020/V39/I14/130

[1] MOMBER A W. A probabilistic model for the erosion of cement-based composites due to very high-speed hydro-abrasive flow [J]. Wear, 2016, 368-369: 39-44.
[2] 黄飞，卢义玉，刘小川，等. 高压水射流冲击作用下横观各向同性岩石破碎机制[J]. 岩石力学与工程学报，2014, 33(7): 1329-1335.
HUANG Fei, LU Yi-yu, LIU Xiao-chuan, et al. Breakage mechanism of transverse isotropic rock subjected to high-pressure water jet [J]. Chinese Journal of Rock Mechanics and Engineering, 2014, 33(7): 1329-1335.
[3] JIANG Hongxiang, DU Changlong, LIU Songyong, et al. Numerical simulation of rock fragmentation under the impact load of water jet [J]. Shock and Vibration, 2014, 2014(3): 118-124.
[4] JIANG Hongxiang, LIU Zenghui, GAO Kuidong. Numerical simulation on rock fragmentation by discontinuous water-jet using coupled SPH/FEA method [J]. Powder Technology, 2017, 312: 248-259.
[5] 司鹄，薛永志. 基于SPH算法的脉冲射流破岩应力波效应数值分析[J]. 振动与冲击，2016, 35(5): 146-152.
SI Hu, XUE Yong-zhi. Numerical analysis for stress wave effects of rock broken under pulse jets [J]. Journal of Vibration and Shock, 2016, 35(5): 146-152.
[6] 强洪夫，范树佳，陈福振，等. 基于SPH方法的聚能射流侵彻混凝土靶板数值模拟[J]. 爆炸与冲击，2016, 36(04): 516-524.
QIANG Hong-fu, FAN Shu-jia, CHEN Fu-zhen, et al. Numerical simulation on penetration of concrete target by shaped charge jet with SPH method [J]. Explosion and Shock Waves, 2016, 36(04): 516-524.
[7] 葛庆子，翁大根，张瑞甫. 飞机撞击特大型LNG储罐全过程仿真分析[J]. 振动与冲击，2016, 35(04): 1-7+21.
GE Qingzi, WENG Dagen, ZHANG Ruifu. Whole process simulation analysis of aircraft's crashing into an extra-large LNG storage tank [J]. Journal of Vibration and Shock, 2016, 35(04): 1-7+21.
[8] BA K, GAKWAYA A. Thermomechanical total Lagrangian SPH formulation for solid mechanics in large deformation problems [J]. Computer Methods in Applied Mechanics and Engineering, 2018, 342: 458-473.
[9] RUSSELL M A, SOUTO-IGLESIAS A, ZOHDI T I. Numerical simulation of Laser Fusion Additive Manufacturing processes using the SPH method [J]. Computer Methods in Applied Mechanics and Engineering, 2018, 341: 163-187.
[10] 林晓东，卢义玉，汤积仁，等. 基于SPH-FEM耦合算法的磨料水射流破岩数值模拟[J]. 振动与冲击，2014, 33(18): 170-176.
LIN Xiao-dong, LU Yi-yu, TANG Ji-ren, et al. Numerical simulation of abrasive water jet breaking rock with SPH-FEM coupling algorithm. Journal of Vibration and Shock, 2014, 33(18): 170-176.
[11] HOLMQUIST T J, JOHNSON G R, COOK W H. A computational constitutive model for concrete subjective to large strain, high strain rates, and high pressure [C] //1th International Symposium on Ballistic, Quebec City, Canada, 1993, 591-600.
[12] Kong Xiangzhen, Fang Qin, Wu Hao, et al. Numerical predictions of cratering and scabbing in concrete slabs subjected to projectile impact using a modified version of HJC material model [J]. International Journal of Impact Engineering, 2016, 75:61-71.
[13] MALVAR L J, CRAWFORD J E, WESEVICH J W, et al. A plasticity concrete material model for DYNA3D [J]. International Journal of Impact Engineering, 1997, 19(9-10): 847-873.
[14] HEYMANN F J. High-speed impact between a liquid drop and a solid surface [J]. International Journal of Applied Physics, 1969, 40(13): 5112-5122.
[15] FIELD J E. Stress waves, deformation and fracture caused by liquid impact [J]. Philosophical Transactions for the Royal Society of London. Philosophical Transactions for the Royal Society of London, 1966, 260(1110): 86-93.