Anti-collapse performance of beam-column substructures based on the composite effect of floor slabs
ZHONG Weihui1,2， TAN Zheng1， SONG Xiaoyan1， MENG Bao1， ZHENG Yuhui1
1.School of Civil Engineering, Xi’an University of Architecture and Technology, Xi’an 710055, China ;
2.Key Lab of Structural Engineering and Earthquake Resistance, Ministry of Education,Xi’an University of Architecture and Technology, Xi’an 710055，China
Abstract：To investigate the failure mode and mechanical mechanism of steel frames under middle column removal scenario, a composite beam-column substructure with bolt and weld rigid connections,being comprised of three columns and two beams, was selected as the research object to conduct monotonic static loading tests.The test results show that the tension flange at the beam end near the failure column fractures first, and the cracks continue to develop upward until the web fractures.The specimen can provide higher resistance in large deformation stage than in the previous bending stage due to the synergistic effect.In addition, a detailed finite element model was established and validated by test results.On this basis, the influence of the peripheral components′ constraints on the anti-collapse performance of the assembly was assessed.The results show that the anti-collapse resistance of the beam-column substructure will be improved by the increase of peripheral components′ constraints.When the constraints provided by peripheral components exceed the critical value, it will have only little effect on bearing capacity against progressive collapse.The anti-collapse resistance of specimens with and without floor slabs were analyzed by a full-scale model.The results show that the peak bearing capacity due to the flexural mechanism of the specimen with floor slabs is increased by 42.0% and that due to the catenary mechanism by 49.9% compared with the specimen without floor slabs.It shows that the composite effect of floor slabs can significantly improve the bearing capacity of the structure by both the flexural mechanism and catenary mechanism.The dynamic response curves of the structure were obtained based on the principle of energy balance.The comparison shows that the existence of floor can make the structure own relatively rich strength redundancy under dynamic load.
钟炜辉1,2，谭政1，宋晓燕1，孟宝1，郑玉辉1. 基于楼板组合效应的梁柱子结构抗倒塌性能研究[J]. 振动与冲击, 2021, 40(10): 261-270.
ZHONG Weihui1,2， TAN Zheng1， SONG Xiaoyan1， MENG Bao1， ZHENG Yuhui1. Anti-collapse performance of beam-column substructures based on the composite effect of floor slabs. JOURNAL OF VIBRATION AND SHOCK, 2021, 40(10): 261-270.
［1］Alternate path analysis & design guidelines for progressive collapse resistance:GSA 2013［S］.Washington, D.C.:United States General Services Administration, 2013.
［2］史艳莉, 石晓飞, 王文达, 等.圆钢管混凝土柱-H钢梁内隔板式节点抗连续倒塌机理研究［J］.振动与冲击, 2016, 35(19):148-155.
SHI Yanli, SHI Xiaofei, WANG Wenda, et al.Progressive collapse mechanism for H-beam-concrete-filled steel tubular column connections with steel inner-diaphragm joints［J］.Journal of Vibration and Shock, 2016, 35(19):148-155.
［3］WANG W, WANG J J, SUN X,et al.Slab effect of composite subassemblies under a column removal scenario［J］.Journal of Constructional Steel Research, 2017, 129(2):141-155.
［4］YANG B, TAN K H, XIONG G,et al.Experimental study about composite frames under an internal column-removal scenario［J］.Journal of Constructional Steel Research, 2016, 121:341-351.
［5］REN P Q, LI Y, LU X Z, et al.Experimental investigation of progressive collapse resistance of one-way reinforced concrete beam-slab substructures under a middle-column-removal scenario［J］.Engineering Structures, 2016,118:28-40.
［6］MENG B, ZHONG W H, HAO J P.Anti-collapse performances of steel beam-to-column assemblies with different span ratios［J］.Journal of Constructional Steel Research, 2018, 140:125-138.
［7］MENG B, ZHONG W H, HAO J P.Anti-progressive collapse behavior of beam-to-column assemblies with bolted-angle connections under different span ratios［J］.Advances in Structural Engineering, 2018, 21(6): 891-905.
［8］ZHONG W H, MENG B, HAO J P.Performance of different stiffness connections against progressive collapse［J］.Journal of Constructional Steel Research, 2017, 135:162-175.
［9］钟炜辉, 宋晓燕, 孟宝, 等.弱轴栓焊连接梁柱子结构抗倒塌性能试验研究［J］.工程科学与技术, 2018, 20(2):1-8.
ZHONG Weihui, SONG Xiaoyan, MENG Bao, et al.Experimental study on anti-collapse performance of beam-column substructure with welded flange-bolted web connection in minor-axis direction［J］.Advanced Engineering Sciences, 2018, 20(2):1-8.
［10］钢结构设计标准：GB 50017—2017［S］.北京: 中国建筑工业出版社, 2017.
［11］组合结构设计规范:JGJ 138—2016［S］.北京: 中国建筑工业出版社, 2016.
［12］Recommended seismic evaluation and upgrade criteria for existing welded steel moment-frame buildings:FEMA-351［S］.California:Federal Emergency Management Agency, 2000.
［13］混凝土结构设计规范：GB 50010—2010［S］.北京: 中国建筑工业出版社, 2010.
［14］YU H L, JEONG D Y.Application of a stress triaxiality dependent fracture criterion in the finite element analysis of unnotched Charpy specimens［J］.Theoretical and Applied Fracture Mechanics, 2010, 54(1):54-62.
［15］LEE Y W, WIERZBICKI T.Quick fracture calibration for industrial use［R］.Cambridge:MIT Impact and Crashworthiness Lab, 2004.
［16］IZZUDDIN B A, VLASSIS A G, ELGHAZOULI A Y, et al.Progressive collapse of multistory buildings due to sudden column loss-part II: application［J］.Engineering Structure, 2008, 30(5):1424-1438.
