Abstract：A new control algorithm of ABS was proposed base on the sliding mode extremum-seeking algorithm, in terms of the fact that the road adhesion coefficient is complex and variable and the optimal slip ratio is difficult to be estimated accurately. This is achieved by adapting the extremum-seeking algorithm as a self-optimization routine that seeks the peak point of the tire force-slip curve, while it is approaching the peak point quickly using the sliding mode variable structure control method. Moreover, the driving condition of braking-in-turn has been taken into consideration. The control law was corrected by introducing the steering wheel angle to compensate for the vehicle lateral stability when cornering. Numerical simulation studies have been conducted to evaluate the proposed control algorithm using a 7-DOF full vehicle model built in MATLAB/Simulink. The simulation results show that the designed controller can quickly find the maximum braking force and optimum slip ratio value with respect to the unknown and possibly changing road conditions. When braking-in-turn, the slip ratio decreases and the tire lateral force increases without overtly increasing the parking time, thereby improving the lateral stability of the vehicle. And the controller can adapt to the variable road adhesion coefficient when road conditions changing.
周兵1，李永辉1，袁希文1, 胡哓岚1，程逸然2. 滑模极值搜索算法ABS控制及对汽车侧向稳定性补偿[J]. 振动与冲击, 2016, 35(4): 121-126.
LI Yonghui1，ZHOU Bing1，YUAN Xiwen1，HU Xiaolan1，CHENG Yiran2 . Extremum-Seeking Control of ABS Braking in Road Vehicles With Lateral Stability Improvement. JOURNAL OF VIBRATION AND SHOCK, 2016, 35(4): 121-126.
[1] Harifi A，Aghagolzadeh A，Alizadeh G. Designing a sliding mode controller for slip control of antilock brake systems[J]. Transportation research part C：emerging technologies. 2008，16(6)：731-741.
[2] Mirzaeinejad H，Mirzaei M. A novel method for non-linear control of wheel slip in anti-lock braking systems[J]. Control Engineering Practice. 2010，18(8)： 918-926.
[3] 王伟达，丁能根，张为等. ABS逻辑门限值自调整控制方法研究与试验验证[J]. 机械工程学报，2010，46(22) ：90-95.
WANG Weida，DING Nenggen，ZHANG Wei，et al. Research and Verification of the Logic Threshold Self-adjusting Control Method for ABS[J]. Journal Of Mechanical Engineering，2010，46(22) ：90-95.
[4] 丁能根，王伟达，余贵珍等. 基于试验知识的ABS自适应控制策略研究与验证[J]. 汽车工程，2009，31(1)：28-32.
DING Nenggen，WANG Weida， YU Zhengui，et al. Research and Validation of the Adaptive ControlStrategy for ABS Based on Experimental Knowledge[J]. Automotive Engineering，2009，31(1)：28-32.
[5] Drakunov S，Ozguner U，Dix P. ABS control using optimum search via sliding modes[J]. Control Systems Technology，IEEE Transactions on. 1995，3(1)：79-85.
[6] G. F. Mauer. A fuzzy logic controller for an ABS braking system[J]. Fuzzy Systems, IEEE Transactions on. 1995, 3(4)：381-388.
[7] 武超，段建民，于涌川等. 气压ABS的模糊自寻优控制器设计与硬件在环验证[J]. 汽车工程，2010，32(11)：989-992.
WU Chao，DUAN Jianmin，YU Yongchuan，et al. Design and HIL Validation of Fuzzy Self-optimizing Controller for Pneumatic ABS[J]. Automotive Engineering，2010，32(11)：989-992.
[8] Zhang C， Ordâoänez R. Extremum seeking control and applications[M]. Springer，2012.
