Virtual Dynamic Balancing for Turbomachine Shafting with Multi-rotor Based on Dynamic Response Analysis
Bin Guangfu1 Zhou Wei1 Wang Weiming2 Li Xuejun1
1. Health Maintenance for Mechanical Equipment Key Lab of Hunan Province, Hunan University of Science and Technology, Xiangtan 411201;
2. Diagnosis and Self-recovering Research Center, Beijing University of Chemical Technology, Beijing 100029
In order to solve the problem of dynamic balancing needed to be started many times for turbomachine shafting with multi-rotor, a virtual dynamic balancing method without trial weights for multi-rotor shafting based on dynamic response analysis is developed in this paper. According to the shafting structure size and operation parameters, the rotor dynamic finite element model was built by simulation technology. Unbalance excitation was applied in the node of finite element model corresponding to the balancing weighed position of multi-rotor respectively. Vibration response value of each measuring point on the shafting balancing speed can be obtained through the steady-state unbalance response analysis, which can replace through many times starting up trial weights to get the shafting weighted influence coefficient of specific balancing location in the process of field whole-machine dynamic balancing. Then, combined with the initial fundamental frequency response value of the shafting vibration measuring points, the required shafting balancing weighted of each rotor can be obtained through the vector calculation. The dynamic balancing experiment at the speed of 1200rpm without trail weights was taken by using the proposed method. The average amplitude reduction was up to 55%. The proposed dynamic balancing method can reduce shutdown times and probability of balancing failure due to the improper trial weight and test error. Moreover, it can also be applied to the field dynamic balancing for large flexible shafting.
宾光富1 周 伟1 王维民2 李学军1. 基于动力学响应分析的透平机械多转子轴系虚拟动平衡研究[J]. 振动与冲击, 2017, 36(18): 8-12.
Bin Guangfu1 Zhou Wei1 Wang Weiming2 Li Xuejun1. Virtual Dynamic Balancing for Turbomachine Shafting with Multi-rotor Based on Dynamic Response Analysis. JOURNAL OF VIBRATION AND SHOCK, 2017, 36(18): 8-12.
[1] 高金吉. 机器故障诊治与自愈化[M]. 北京: 高等教育出版社, 2012.
Gao J J. Machine fault diagnosis and self-recovering[M]. Beijing: Higher Education Press, 2012.
[2] Foiles W C, Allaire P E, Gunter E J. Review: rotor balancing[J]. Shock and Vibration, 1998, 5(5):325-336.
[3] El-Shafei A, El-Kabbany S, Younan A A. Rotor balancing without trial weights[J]. Journal of Engineering for Gas Turbines and Power, 2004, 126(3):604-609
[4] Lund J W, Tonnesen J. Analysis and experiments on multi-plane balancing of a flexible rotor[J]. Journal of Engineering for industry, 1972, 94 (1):233-242.
[5] Gnielka P. Modal balancing of flexible rotors without test run: an experimental investigation[J]. Journal of Sound and Vibration, 1983, 90(2):157-172.
[6] Li G X, Lin Z L, Allaire P E. Robust optimal balancing of high-speed machinery using convex optimization[J]. Journal of Vibration and Acoustics, 2008, 130(3): 031008-1-12.
[7] Kang Y, Lin T W, Chang Y J, et al. Optimal balancing of flexible rotors by minimizing the condition number of influence coefficients[J]. Mechanism and Machine Theory, 2008, 43(7): 891-908.
[8] Pennacchi P, Chatterton S, Ricci R. Rotor balancing using high breakdown-point and bounded-influence estimators[J]. Mechanical Systems and Signal Processing, 2010, 24(3): 860-872.
[9] Lees A W, Sinha J K, Friswell M I. Model-based identification of rotating machines[J]. Mechanical Systems and Signal Processing, 2009, 23(6):1884-1893.
[10]Bertoneri M, Forte P. Turbomachinery high speed modal balancing: Modeling and testing of scale rotors[J]. Mechanisms and Machine Science, 2015, 21:15-25.
[11]Bin G F, Li X J, Wu J G, et al. Virtual dynamic balancing method without trial weights for multi-rotor series shafting based on finite element model analysis. Journal of Renewable and Sustainable Energy[J]. 2014, 6(04): 042014-1-14.
[12]徐宾刚, 屈梁生, 孙瑞祥. 基于影响系数法的柔性转子无试重平衡法研究[J]. 西安交通大学学报,2000,34(7): 63-67.
Xu B G, Qu L S, Sun R X. Banalcing of flexible rotors without test weights[J]. Journal of Xi’an Jiao Tong University, 2000, 34(7):63-67.
[13]王维民, 高金吉, 江志农, 等. 旋转机械无试重现场动平衡原理与应用[J]. 振动与冲击, 2010, 29(2):212-215.
Wang W M, Gao J J, Jiang Z N, et al. Principle and application of no trial weight field balancing for a rotating machinery[J]. Journal of Vibration and Shock, 2010, 29(2):212-215.
[14]黄金平, 任兴民, 邓旺群. 利用升速响应振幅进行柔性转子的模态平衡[J]. 机械工程学报, 2010, 46(5): 55-62.
Huang J P, Ren X M, Deng W Q. Novel modal balancing of flexible rotor by using the run-up amplitude[J]. Journal of Mechanical and Engineering, 2010, 46(5): 55-62.
[15]宾光富, 何立东, 高金吉, 李立波. 基于模态振型分析的大型汽轮机低压转子高速动平衡方法. 振动与冲击, 2013, 32(14):87-92.
Bin G F, He L D, Gao J J, Li L B. The High-speed Dynamic Balancing Method for Large Steam Turbine Low Pressure Rotor Based on Modal Shape Analysis[J]. Journal of Vibration and Shock, 2013, 32(14):87-92.
[16]施维新. 柔性转子轴系平衡技术的发展[J].中国电力, 2011, 44(02):31-36.
Shi W X. Development of flexible rotor shaft balancing technology[J]. Electric Power, 2011, 44(02):31-36.
[17]高庆水, 邓小文, 张 楚, 等. 单支撑1000MW超超临界汽轮机轴系不平衡响应分析[J]. 振动与冲击, 2014, 33(14): 201-205.
Gao Q S, Deng X W, Zhang C, et al. Unbalance response for 1000MW ultra supercritical turbine with single bearing support[J]. Journal of Vibration and Shock, 2014, 33(14): 201-205.
[18]Chen W J, Gunter E J. Introduction to Dynamics of Rotor-Bearing Systems [M]. Victoria: Trafford Publishing, UK, 2010.
