基于动态横向转移载荷的轮式装载机侧倾稳定性研究

摘要
图/表
参考文献(15)
相关文章 (15)

全文: PDF (1265 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要为研究轮式装载机动态侧倾稳定性，在考虑车身侧倾和动臂俯仰的基础上，构建基于拉格朗日法和包含动坐标系的轮式装载机十自由度侧倾动力学模型，求解出非平稳路面与发动机耦合激励下的侧倾响应，推导出表征侧倾稳定性的动态横向转移载荷方程，并分析了横向坡度角、动臂结构参数和转弯速度变化对侧倾角与动态横向转移载荷的影响趋势。结果表明：车身侧倾角和动态横向转移载荷随横向坡度角、动臂质量和举升角以及转弯速度的增加而不断增大，但横向坡度角和动臂举升角对侧倾稳定性的影响灵敏度较高；当车身侧倾角超过临界横向坡度角时，两侧车轮垂向载荷发生完全动态横向转移，使一侧车轮产生离地现象进而导致侧倾；上述模型和动态横向载荷转移表征方法可为后续的性能优化提供研究方法和理论基础。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	徐向阳1
	艾星1
	宋朝省2
	朱才朝2

关键词 ：横向转移载荷, 轮式装载机, 动力学模型, 动态响应, 侧倾角

Abstract：In order to study the dynamic roll stability of wheel loader,a ten-degree-of-freedom roll dynamics model of wheel loader with dynamic coordinate system was constructed based on the Lagrangian method considering body roll and boom pitch.The roll response under the coupling excitation of non-stationary road surface and engine was calculated and the dynamic lateral transfer load equation was deduced to characterize the roll stability.The influence trend of lateral slope angle, boom structure parameters and turning speed parameters on the roll angle and dynamic transfer load was analyzed.The results show that the body roll angle and dynamic lateral transfer load raises with the increase of lateral slope angle, boom mass and lifting angle, as well as turning speed.And the lateral slope angle and boom lifting angle have higher sensitivity on the roll stability.When the body roll angle exceeds the critical lateral slope angle, the vertical load on both sides of the wheels completely shifts,laterally and dynamically.Causing the fact that one side of the vehicle is off the ground, which leads to roll.The above models and dynamic lateral load transfer characterization methods can provide a research method and theoretical basis for subsequent performance optimization.

Key words： lateral transfer load wheel loader dynamic model dynamic response roll angle

收稿日期: 2018-09-13 出版日期: 2020-05-15

引用本文:

徐向阳1，艾星1，宋朝省2，朱才朝2. 基于动态横向转移载荷的轮式装载机侧倾稳定性研究[J]. 振动与冲击, 2020, 39(10): 163-169.
XU Xiangyang1,AI Xing1,SONG Chaosheng2,ZHU Caichao2. Roll stability of wheel loader based on dynamic lateral transfer load. JOURNAL OF VIBRATION AND SHOCK, 2020, 39(10): 163-169.

链接本文:

http://jvs.sjtu.edu.cn/CN/ 或 http://jvs.sjtu.edu.cn/CN/Y2020/V39/I10/163

[1] Aoki A, Marumo, Kageyama I. Effects of multiple axles on the lateral dynamics of multi-articulated vehicles[J]. Vehicle System Dynamics, 2013, 51(3): 338-359.

[2] Takano S, Nagai M, Taniguchi T, et al. Study on avehicle dynamics model for improving roll stability[J]. JSAE Review, 2003, 24(2): 149-156.

[3] Hakgu Kim, Kwangseok Oh, KyungeunKo. et al. Modeling, validation and energy flow analysis of a wheel loader[J]. Journal of mechanical science and technology, 2016, 30(2): 603-610.

[4] Dahmani H, Chadli M, Rabhi A, et al. Vehicledynamic estimation with road bank angle consideration forrollover detection: Theoretical and experimental studies[J]. Vehicle System Dynamics, 2013, 51(12): 1853-1871.

[5] Kang J, Yoo J, Yi K. Driving Control Algorithm for Maneuverability Lateral Stability and Rollover Prevention of 4WD Electric Vehicles With Independently Driven Front and Rear Wheels[J]. IEEE Transactions on Vehicular Technology, 2011, 60(7): 2987-3001.

[6] Li X F, Wang G Q, Yao Z W. Research on lateral stability and rollover mechanism of articulated wheel loader[J]. Mathematical and computer modelling of dynamical systems, 2014, 20(3): 248-263.

[7] Zhu Q, Yuan,X, Chun S, et al. Multi-Sensor Based Online Attitude Estimation and Stability Measurement of Articulated Heavy Vehicles[J]. Sensors, 2018, 18(1): 212.

[8] 宋朝省，翁燕祥，朱才朝，等. 考虑轮齿修形的电动车轮边减速器动态啮合性能研究[J]. 振动与冲击，2017, 36(20): 254-260.

Song Chaoxing, Wen Yanxiang, Zhu Caichao, et al. A study on the dynamics of wheel-rim reducers used in electric vehicles considering gear teeth modifications[J]. Journal of vibration and shock, 2017, 36(20): 254-260.

[9] 朱才朝，唐倩，黄泽好，等. 人-机-路环境下摩托车刚柔耦合系统动力学研究[J]. 机械工程学报，2009, 45(5): 225-229.

ZHU Caichao, TANG Qian, HUANG Zehao, et al. Dynamic Study for Driver-motorcycle-road System with Rigid-flexible Coupling[J]. Journal of Mechanical Engineering, 2009, 45(5): 225-229.

[10] 刘鹏飞，王开云，翟婉明. 高速客车悬挂系统静挠度分配对运行平稳性的影响[J]. 西南交通大学学报，2013, 48(2): 193-198.

LIU Pengfei, WANG Kaiyun, ZHAI Wanming. Effect of Distributions of Static Suspension Deflection on Ride Comfort of High-Speed Passenger Cars[J]. Journal of Southwest Jiaotong University, 2013, 48(2): 193-198.

[11] 朱天军，宗长富，吴炳胜，等. 基于改进TTR算法的重型车辆侧翻预警系统[J]. 机械工程学报，2011, 47(10): 88-94.

ZHU Tianjun, ZONG Changfu, WU Bingsheng, et al. Roll state estimation and active control of vehicles considering road uneven disturbances[J]. Journal of Mechanical Engineering, 2011, 47(10): 88-94.

[12] 张亮修，周静，成强，等. 考虑路面不平输入的车辆侧倾状态估计及主动控制[J]．振动与冲击，2018, 37(5): 134-141.

ZHANG Liangxiu, ZHOU Jing, CHENG Qiang, et al. Roll state estimation and active control of vehicles considering road uneven disturbances[J]. Journal of vibration and shock, 2018, 37(5): 134-141.

[13] 刘伟，姜毅，董晓彤，等. 多轴载重车侧翻模型研究[J]. 振动与冲击，2018, 37(9): 127-132.

LIU Wei1, JIANG Yi, DONG Xiaotong, et al. Rollover model of multi-axle trucks[J]. Journal of vibration and shock, 2018, 37(9): 127-132.

[14] 刘杰，林慕义，孙大刚. 轮式.装载机行驶稳定系统减振性能分析[J]. 农业机械学报，2007, 38(10): 183-185.

Liu Jie, Lin Muyi, Sun Dagang. Analysis of vibration reduction performance of wheel loader driving stability system[J]. Transactions of the Chinese Society of Agricultural Machinery, 2007, 38(10): 183-185.

[15] Zongwei Yao, Guoqiang Wang, Xuefei Li, Junna Qu, Yuxin Zhang and Yonghai Yang. Dynamic simulation for the rollover stability performances of articulated vehicles. Proc IMechE Part D: J Automobile Engineering, 2013, 1-13.