Abstract：Here, a calculating method of clamp band connection stiffness was proposed. Based on considering deformation of interface frame, the influence of clamp block deformation of clamp band device (CBD) was added. The numerical calculation results obtained with the proposed method were modified using the finite element calculation results. This method was verified with tests. The calculated results obtained with this method were compared with test ones, and the calculation deviation was 3.1% to verify the correctness of this method. Based on this method, effects of clamp block deformation on clamp band connection stiffness were analyzed. The results showed that deformation of interface frame is the most important factor affecting clamp band connection stiffness, but considering clamp block deformation can improve the calculation accuracy. Furthermore, the method to improve clamp band connection stiffness through increasing the pre-tightening force in engineering was analyzed quantitatively. The example calculation results showed that the relationship between pre-tightening force and clamp band connection stiffness has obvious nonlinear characteristics: when pre-tightening force increases within 10%, clamp band connection stiffness increases in the same proportion; while the former increases by 10%-30%, the latter increases by 10%-20%; after the former increases by more than 30%, increase in the former can’t improve the latter.
康士朋，楼云锋，王添翼，丁齐林，王小卫. 包带装置轴向连接刚度计算与分析[J]. 振动与冲击, 2021, 40(19): 172-179.
KANG Shipeng, LOU Yunfeng, WANG Tianyi, DING Qilin, WANG Xiaowei. Calculation and analysis of axial connection stiffness of clamp band device. JOURNAL OF VIBRATION AND SHOCK, 2021, 40(19): 172-179.
［1］秦朝烨，褚福磊，阎绍泽.包带连接特性及星-箭-包带连接结构耦合动力学的研究进展［J］.力学进展，2012，42(4)：437-444.
QIN Zhaoye, CHU Fulei, YAN Shaoze. Advances in study on joint behavior of clamp band and dynamics of spacecraft-launch vehicle-clamp band coupling system［J］. Advances in Mechanics, 2012, 42(4): 437-444.
［2］秦朝烨，褚福磊，阎绍泽.包带式星箭连接结构轴向刚度研究［J］.宇航学报，2009，30(5)：2080-2085.
QIN Zhaoye, CHU Fulei, YAN Shaoze. Axial stiffness analysis of clamp band system［J］. Journal of Astronautics, 2009, 30(5): 2080-2085.
［3］QIN Z Y, YAN S Z, CHU F L. Finite element analysis of the clamp band joint［J］. Applied Mathematical Modeling, 2012, 36: 463-477.
［4］QIN Z Y, YAN S Z, CHU F L. Dynamic analysis of clamp band joint system subjected to axial vibration［J］. Journal of Sound and Vibration, 2010, 329: 4486-4500.
［5］QIN Z Y, YAN S Z, CHU F L. Improved formulation for predicting the load capacity of marman clamps［J］. Journal of Spacecraft and Rockets, 2017, 54(2): 395-402.
［6］白绍竣，尉飞，郑钢铁.包带连接建模与非线性动力学特性分析［J］. 振动与冲击，2010，29(5)：5-10.
BAI Shaojun, WEI Fei, ZHENG Gangtie. Modeling of a marman calmp band joint and its nonlinear dynamic analysis［J］. Journal of Vibration and Shock, 2010, 29(5): 5-10.
［7］NASA Goddard Space Flight Center. Marman clamp system design guidelines［R］. Maryland: NASA Goddard Space Flight Center, 2000.
［8］唐乾刚，孙世贤. 包带式星箭锁紧预紧力分析［J］. 国防科技大学学报，1996，18(2)：20-25.
TANG Qiangang, SUN Shixian. An analysis of preforce in the locking device of the satellite and launching vehicle with wrapband［J］. Journal of National University of Defense Technology, 1996, 18(2): 20-25.
［9］张文明，李委托.包带式星箭解锁装置预紧力影响因素分析［J］.航天器工程，2013,22(2)：50-54.
ZHANG Wenming, LI Weituo. Research on influencing factor on V-clamp band preload［J］. Spaceraft Engineering, 2013,22(2)：50-54.
［10］ROBERT D T, MICHAEL E. Nonlinear finite element evaluation of marman clamp structural capability［R］. Virginia: AIAA, 1994.
［11］ROME J I, GOYAL V K, MARTINO N E. Techniques for finite element analysis of clamp band system［C］∥50th AIAA/ASME/ASCE/AHS/ASC Structures, Structural Dynamics, and Materials Conference. Palm: AIAA, 2009.
［12］康士朋，唐杰，宋林郁.温度变化对包带装置预紧力影响分析与验证［J］.宇航学报，2016，37(9)：1122-1128.
KANG Shipeng, TANG Jie, SONG Linyu. Analysis and verification of the effect of temperature variation on the preload of clamp band device［J］. Journal of Astronautics, 2016, 37(9): 1122-1128.
