钢管束组合剪力墙变形性能研究及有限元分析

摘要
图/表
参考文献(15)
相关文章 (15)

全文: PDF (4316 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要提出一种新型钢板剪力墙结构-钢管束组合剪力墙。对7组钢管束组合剪力墙在往复荷载作用下的性能进行试验研究，分析其滞回曲线及骨架曲线，并对墙体变形能力及钢板应变性能进行了分析，研究墙体在不同阶段破坏形态。同时以该试验为基础，采用ABAQUS有限元软件分析钢管束组合剪力墙的力学性能。研究结果表明：钢管束组合剪力墙具有较高的承载力和良好的抗震性能，滞回曲线饱满。对不同钢管束截面，钢板厚度，剪跨比以及是否布置栓钉等参数进行了分析，对比其受力模式。通过试验现象、应力应变分析及有限元分析可以看出，试件最终破坏多为墙体下部出现钢板受压屈曲或受拉撕裂及混凝土压溃。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	陈志华1
	2
	姜玉挺2
	张晓萌2
	杨强跃3
	李文斌3
	胡立黎3
	李杰2

关键词 ：钢管束组合剪力墙, 试验研究, 变形分析, 破坏形态, 有限元分析

Abstract：A new type of steel plate shear wall—steel tube bundle composite shear wall was put forward. Seven steel tube bundle composite shear walls were tested under cycle load, and their hysteretic curves and skeleton curves were analyzed. The deformation property and strain performance of walls as well as their failure modes under different stages were researched. Based on the experiments, the mechanical property of the composite shear wall was simulated by ABAQUS. Research results showed that the steel tube bundle composite shear wall had high bearing capacity and good seismic performance. In order to compare their bearing mode, different parameters including the section of steel tube bundle, the thickness of steel plate, the shear span ratio and whether the stud was decorated were analyzed. Experiment phenomenon, stress-strain analysis and finite element simulation showed that the eventual damage of the specimens usually came from the compression buckling or tension torn of the steel plate and the concrete crushing at the lower part of the walls.

Key words： steel tube bundle composite shear wall experimental study deformation analysis failure mode finite element analysis

收稿日期: 2016-01-05 出版日期: 2017-09-28

引用本文:

陈志华1,2，姜玉挺2，张晓萌2，杨强跃3，李文斌3，胡立黎3，李杰2. 钢管束组合剪力墙变形性能研究及有限元分析[J]. 振动与冲击, 2017, 36(19): 36-45.
CHEN Zhi-hua1,2，JIANG Yu-ting2，ZHANG Xiao-meng2，YANG Qiang-yue3，LI Wen-bin3，HU Li-li3，LI Jie2. Deformation Property Research and Finite Element Analysis of Steel Tube Bundle Composite Shear Wall. JOURNAL OF VIBRATION AND SHOCK, 2017, 36(19): 36-45.

链接本文:

http://jvs.sjtu.edu.cn/CN/ 或 http://jvs.sjtu.edu.cn/CN/Y2017/V36/I19/36

[1] Wright H. The axial load behaviour of composite walling[J]. Journal of Constructional Steel Research, 1998, 45(3): 353-375.
[2] Wright H D, Gallocher S C. The behaviour of composite walling under construction and service loading[J]. Journal of Constructional Steel Research, 1995, 35(3): 257-273.
[3] 吕西林，干淳洁，王威. 内置钢板钢筋混凝土剪力墙抗震性能研究[J]. 建筑结构学报，2009，30(5)：89-96.
LU Xi-lin, GAN Chun-jie, WANG Wei. Study on seismic behavior of steel plate reinforced concrete shear walls [J]. Journal of Building Structures, 2009, 30(5): 89-96.
[4] ZHAO Qiu-hong, Astaneh-Asl A. Cyclic behavior of traditional and innovative composite shear walls[J]. Journal of Structural Engineering, 2004, 130(2): 271-284.
[5] Link R A, Elwi A E. Composite concrete-steel plate walls: analysis and behavior[J]. Journal of Structural Engineering, 1995, 121(2): 260-271.
[6] Emori K. Compressive and shear strength of concrete filled steel box wall[J]. Steel Structures, 2002, 68(2): 29-40.
[7] 聂建国，胡红松，李盛勇等. 方钢管混凝土暗柱内嵌钢板-混凝土组合剪力墙抗震性能试验研究[J]. 建筑结构学报，2011，32(11)：74-81.
NIE Jian-guo, HU Hong-song, LI Sheng-yong，et al. Experimental study on seismic behavior of steel plate reinforced concrete composite shear walls withsquare CFST concealed columns[J]. Journal of Building Structures, 2011,
32(11): 74-81.
[8] 聂建国，卜凡民，樊建生. 低剪跨比双钢板-混凝土组合剪力墙抗震性能试验研究[J]. 建筑结构学报，2011，32(11)：74-81.
NIE Jian-guo, BU Fan-min, FAN Jian-sheng. Experimental research on seismic behavior of low shear-span ratio composite shear wall with double steel plates and infill concrete[J]. Journal of Building Structures, 2011, 32(11):
74-81.
[9] 纪晓东，蒋飞明，钱稼茹等. 钢管-双层钢板-混凝土组合剪力墙抗震性能试验研究[J]. 建筑结构学报，2013，34(6)：75-83.
JI Xiao-dong, JIANG Fei-ming,QIAN Jia-ru，et al.Experimental study on seismic behavior of steel tube-double steel plate-concrete composite shear walls[J]. Journal of Building Structures, 2013, 34(6): 26-38.
[10] 牟在根，张福建，李黎明. 两边连接竖向加劲式钢板剪力墙简化模型[J]. 天津大学学报（自然科学与工程技术版），2014，47(增刊)：30-36.
MOU Zai-gen, ZHANGFu-jian,LI Li-ming.Simplified Model for Two-Side Constraint Steel Plate Shear Wall(SPSW)with Vertical Stiffeners [J]. Journal of Tianjin University,2014,47(Suppl):30-36.
[11] ZHANG Xiao-meng, QIN Ying, CHEN Zhi-hua. Experimental seismic behavior of innovative composite shear walls [J]. Journal of Constructional Steel Research, 2016, 116: 218-232.
[12] 李忠献. 工程结构试验理论与技术[M].天津：天津大学出版社，2004.
LI Zhong-xian. Theory and technique of engineering structure experiments. Tianjin:Tianjin University Press,2004.
[13] 杨亚彬，曹万林. CFST边框内藏桁架高剪力墙抗震试验与有限元分析[J]. 振动与冲击，2014，33(11)：107-113.
YANG Ya-bin, CAO Wan-lin.Seismic Testing and Finite Element Analysis of Shear Wall with CFST Columns and Concealed Trusses[J]. Journal of Vibration and Shock,2014,33(11):107-113.
[14] Katrin Beyer, Alessandro Dazio, M. J. Nigel Priestley. Shear Deformations of Slender Reinforced Concrete Walls under Seismic Loading[J]. ACI Structure Journal , 2011, 108(2): 167-177.
[15] 韩林海，陶忠，王文达. 现代组合结构和混合结构—试验、理论和方法[M].北京：科学出版社，2009.
HAN Lin-hai,TAO Zhong,WANG Wen-da. Advanced Composite and Mixed Structures—Testing,Theory and Design Approach. Beijing:Science Press Ltd,2009.