基于非线性静、动力方法的RC简支梁桥连梁装置参数优化研究

江辉;李宇;熊智阳;杨庆山;朱晞;倪永军

振动与冲击 ›› 2012, Vol. 31 ›› Issue (1) : 86-91,9.

PDF(2250 KB)
PDF(2250 KB)
振动与冲击 ›› 2012, Vol. 31 ›› Issue (1) : 86-91,9.
论文

基于非线性静、动力方法的RC简支梁桥连梁装置参数优化研究

  • 江辉1; 李宇2; 熊智阳3; 杨庆山1; 朱晞1; 倪永军1
作者信息 +

Parameter optimization study for unseating prevention device of rc simple-supported girder bridge based on nonlinear static and dynamic analysis methods

  • JIANG Hui; Li Yu; Xiong Zhi-yang; YANG Qing-Sshan; ZHU Xi; NIYong-jun1
Author information +
文章历史 +

摘要

连梁拉杆装置是防止强震下RC梁式桥纵向落梁的有效措施,需要对其合理刚度取值进行研究。以典型的铁路RC简支梁桥为对象,采用基于FEMA440性能点轨迹法的能力谱分析方法,以现行《铁路工程抗震设计规范》设计谱及汶川地震动为需求,讨论了不同的场地类型和设防烈度下连梁拉杆的最优刚度分布。研究表明,场地类型对连梁装置刚度取值无显著影响,在8度罕遇烈度设防的四种场地下,连梁装置的刚度均可在0.05~0.15倍的梁体线刚度范围内取值,可有效抑制墩、梁相对位移及桥梁整体地震响应。设防烈度对刚度取值有显著影响,当PGA不超过0.2g时,可不予设置;当PGA为0.4g和0.6g时,连梁拉杆的合理刚度可分别取为0.1倍和0.2倍的梁体线刚度。采用非线性动力时程方法验证了上述结论的合理可靠性,可供桥梁抗震设计及规范修编参考

Abstract

Unseating prevention device is an effective measure to forefend beams from falling from RC girder bridges, so it is necessary to study thoroughly the reasonable range of the stiffness of this rubber-tie bar device. Based on capacity spectra method of FEMA440, a typical railway RC simple-supported girder bridge was taken to discuss the stiffness distribution for different site soils and fortification intensities under the seismic demand of current design spectra and Wenchuan Earthquake. It indicates that the site soil has no obvious influence on the stiffness value of unseating prevention device, and the rational stiffness ratio is between 0.05~0.15 times of the linear stiffness of the adjacent beams for 8 degree of high-level fortification intensity, in which condition the relative displacement between the piers and beams as well as the overall structural response can be effectively repressed. However, the fortification intensity has remarkable influence on the stiffness. When PGA is less than 0.2g, it is not essential to install unseating prevention device, and when PGA is 0.4g and 0.6g, the reasonable stiffness ratio may be 0.1 and 0.2 respectively. The rationality and reliability of above conclusion was validated by nonlinear time history analysis, which can provide reference for the seismic design of RC bridges and the revision of related seismic design codes

关键词

RC简支梁桥 / 连梁装置 / 抗震设计 / 拉杆刚度 / 非线性分析

Key words

simple-supported girder bridge / unseating prevention device / seismic design / stiffness of rubber-tie bar device / nonlinear analysis

引用本文

导出引用
江辉;李宇;熊智阳;杨庆山;朱晞;倪永军. 基于非线性静、动力方法的RC简支梁桥连梁装置参数优化研究[J]. 振动与冲击, 2012, 31(1): 86-91,9
JIANG Hui;Li Yu;Xiong Zhi-yang;YANG Qing-Sshan;ZHU Xi;NIYong-jun. Parameter optimization study for unseating prevention device of rc simple-supported girder bridge based on nonlinear static and dynamic analysis methods[J]. Journal of Vibration and Shock, 2012, 31(1): 86-91,9

PDF(2250 KB)

Accesses

Citation

Detail

段落导航
相关文章

/