波形钢腹板PC简支箱梁桥局部与整体动力冲击系数的计算分析

冀伟1,2,邓露2,何维2,刘世忠1,蔺鹏臻1

振动与冲击 ›› 2017, Vol. 36 ›› Issue (8) : 22-28.

PDF(1396 KB)
PDF(1396 KB)
振动与冲击 ›› 2017, Vol. 36 ›› Issue (8) : 22-28.
论文

波形钢腹板PC简支箱梁桥局部与整体动力冲击系数的计算分析

  • 冀伟1,2,邓露2,何维2,刘世忠1,蔺鹏臻1
作者信息 +

Local and global impact factors analysis for PC box girder bridges with corrugated steel webs

  • JI Wei1,2,DENG Lu2,HE Wei2,LIU Shizhong1,LIN Pengzhen1
Author information +
文章历史 +

摘要

为合理分析和计算波形钢腹板PC简支箱梁桥局部与整体的动力冲击系数,分别建立了波形钢腹板PC箱梁桥和车辆结构的振动方程,并根据车轮与桥面的接触关系形成两者耦合振动的动力方程。采用MATLAB和ANSYS软件分别建立了三维的车辆模型和波形钢腹板PC箱梁桥的有限元模型,并在考虑路面平整度随机激励的作用下,利用MATLAB软件求解了车桥耦合系统的动力方程,得到桥梁结点的位移振动响应;依据动位移与静位移的关系,计算出了波形钢腹板PC箱梁桥的局部及整体的动力冲击系数;对所求得的局部及整体动力冲击系数进行了不同车辆类型、不同车道数加载,不同行驶速度和不同路面情况下的参数分析,并与我国现行规范和美国现行AASHTO规范进行对比分析,最终提出了波形钢腹板PC简支箱梁桥局部及整体动力冲击系数的合理确定方法,所得结论可为波形钢腹板PC箱梁桥动力冲击系数的确定提供参考。

Abstract

In order to calculate and analyze the local and global impact factors (IMs) of a simply supported box girder bridge with corrugated steel webs (CSWs) accurately,the motion equations of the bridge and vehicle were established.The two system equations were coupled through the contact condition.Three dimensional vehicle models were established by using the MATLAB software and the finite element model of the PC box girder bridge with CSWs was established by using the ANSYS software,respectively.Considering the random excitation effects of the road roughness,the vibration responses of the bridge nodes could be obtained by using the MATLAB program to solve the dynamic equations of the vehicle-bridge system.According to the relationship between the dynamic and the static deflection,the local and global IMs of the PC box girder bridge with CSWs could be calculated.The obtained local and global IMs were compared and the relationship between the obtained IM and four important parameters,including the type of vehicle,the number of the loaded lanes,vehicle speed,and the road surface condition,was studied.The obtained local and global IMs were also compared with the China code JTG D60—2015 and the AASHTO standard specification.Finally,the reasonable determination method to calculate the local and global dynamic IMs of a simple supported PC box girder bridge with CSWs was presented.The conclusions can provide a reference for determining IMs of this type of bridges.

关键词

波形钢腹板 / 组合箱梁 / 车桥耦合振动 / 动力冲击系数 / 路面平整度

Key words

corrugated steel web / composite box girder / vehicle-bridge interaction / dynamic impact factor / road roughness

引用本文

导出引用
冀伟1,2,邓露2,何维2,刘世忠1,蔺鹏臻1. 波形钢腹板PC简支箱梁桥局部与整体动力冲击系数的计算分析[J]. 振动与冲击, 2017, 36(8): 22-28
JI Wei1,2,DENG Lu2,HE Wei2,LIU Shizhong1,LIN Pengzhen1. Local and global impact factors analysis for PC box girder bridges with corrugated steel webs[J]. Journal of Vibration and Shock, 2017, 36(8): 22-28

参考文献

[1] 陈宜言. 波形钢腹板预应力混凝土桥设计与施工[M]. 北京: 人民交通出版社, 2009.
   CHEN Yiyan. Composite design and construction of composite box girder with corrugated steel webs [M]. Beijing: China Communications Press, 2009.
[2] Nguyen N D, Han S R, Kim J H, et al. Moment modification factors of I-girder with trapezoidal web corrugations under moment gradient[J]. Thin-Walled Structures, 2012, 57: 1-12.
[3] Hassanein M F, Kharoob O F. Shear buckling behavior of tapered bridge girders with steel corrugated webs[J]. Engineering Structures, 2014, 74: 157-169.
[4] Nguyen N D, Kim S N, Han S R, et al. Elastic lateral-torsional buckling strength of I-girder with trapezoidal web corrugations using a new warping constant under uniform moment[J]. Engineering Structures, 2010, 32: 2157-2165.
[5] Oh J Y, Lee D H, Kim K S. Accordion effect of prestressed steel beams with corrugated webs[J]. Thin-Walled Structures, 2012, 57: 49-61.
[6] 江克斌, 丁勇, 杨建奎等. 波形钢腹板PC组合箱梁纯扭作用下抗扭承载力试验研究[J]. 工程力学, 2013, 30(6): 175-182.
JIANG Kebin, DING Yong, YANG Jiankui, et a1. Experimental study on ultimate torsional strength of PC composite box-girder with corrugated steel webs under pure torsion[J]. Engineering Mechanics, 2013, 30(6): 175-182.
[7] 吴文清, 万水, 叶见曙等. 波形钢腹板组合箱梁剪力滞效应的空间有限元分析[J]. 土木工程学报, 2004, 37(9): 31-36.
    WU Wenqing, WAN Shui, YE Jianshu, et a1. 3-Dfinite element analysis on shear lag effect in composite box girder with corrugated steel web [J]. China Civil Engineering Journal, 2004, 37(9): 31-36.
[8] 刘保东, 任红伟, 李鹏飞. 考虑波纹钢腹板箱梁特点的挠度分析[J]. 中国铁道科学, 2011, 32(3): 21-26.
LIU Baodong, REN Hongwei, LI Pengfei. Deflection analysis considering the characteristics of box girder with corrugated steel webs[J]. China Railway Science, 2011, 32(3): 21-26.
[9] 刘保东, 陈海波, 任红伟. 波形钢腹板混凝土箱梁动力特性改善研究[J]. 中国铁道科学, 2008, 29(3): 29-33.
LIU Baodong, CHEN Haibo, REN Hongwei. Improvement study of the dynamic characteristics for concrete box-girder with corrugated steel webs. China Railway Science, 2008, 29(3): 29-33.
[10] 韦忠瑄, 孙鹰, 沈庆等. 波形钢腹板PC组合箱梁的动力特性研究. 固体力学学报, 2011, 32: 394-398.
WEI Zhongxuan, SUN Ying, SHEN Qing, et al. Study on dynamic properties of the prestressed concrete box-girder with corrugated steel webs. [J]. Chinese Journal of Solid Mechanics, 2011, 32: 394-398.
[11] 李波, 刘保东, 李鹏飞等. 波纹钢腹板组合箱梁应力相关阻尼特性研究. 振动与冲击, 2012, 31(6): 68-71.
LI Bo, LIU Baodong, LI Pengfei, et al. Stress-related damping characteristic of a composite box-girder with corrugated steel webs[J]. Journal of Vibration and Shock, 2012, 31(6): 68-71.
[12] 陈志兴. 波形钢腹板箱梁桥车桥耦合振动冲击系数研究[J].山西建筑, 2014, 40(13): 176-178.
CHEN Zhixing. Study on impact coefficient of coupling vibration of vehicle bridge girder bridge with corrugated steel web box[J]. Shanxi Architecture, 2014, 40(13): 176-178.
[13] JTG D60-2015 公路桥涵设计通用规范[S]. 北京: 人民交通出版社, 2015.
    JTG D60-2015 General Code for Design of Highway Bridges and Culverts[S]. Beijing: China communications press, 2015.
[14] 冀伟, 刘世忠, 蔺鹏臻. 波形钢腹板组合箱梁振动频率分析与试验[J]. 中国公路学报, 2013, 26(5): 102-107.
JI Wei, LIN Shizhong, LIN Pengzhen. Study on influencing factors of vertical frequency of the box girder with corrugated steel webs[J]. China Journal of highway and transport, 2013, 26(5): 102-107.
[15] Deng L, Cai C S. Identification of parameters of vehicles moving on bridges [J]. Engineering Structures, 2009, 31(10):2474-2485.
[16] Deng L, Cai C S. Development of dynamic impact factor for performance evaluation of existing multi-girder concrete bridges [J]. Engineering Structures, 2010, 32(1): 21-31.
[17] American Association of State Highway and Transportation Officials (AASHTO) (2012) LRFD bridge design specifications. Washington DC, USA.
[18] Wang T, Huang D. Cable-stayed bridge vibration due to road surface roughness[J]. Journal of structural engineering, 1992, 118: 1354-1374.
[19] International Organization for Standard (ISO). (1995). Mechanical vibration - road surface profiles - reporting of measured data. ISO 8068: 1995(S). ISO, Geneva, 1995.
[20] Deng L. System identification of bridge and vehicle based on their coupled vibration[D]. Louisiana State University, 2009.

PDF(1396 KB)

Accesses

Citation

Detail

段落导航
相关文章

/