针对国内某地铁车辆因车轮多边形造成舒适性差的问题展开动力学仿真和线路测试研究。理论上简要分析了车轮多边形产生的原因并建立地铁车辆动力学模型,计算得到转向架各部件的振动固有频率,并发现车辆平稳性在40km/h速度下异常恶劣。建立以轨道不平顺为输入、电机位移为输出传递函数,分析了40km/h速度下车轮多边形产生的外部激励43.6Hz与直线电机垂向固有频率接近从而导致电机发生共振,进一步加剧了车轮多边形恶化。线路跟踪实验表明,车体上的平稳性指标同样在40km/h时异常恶化,恶化程度随车轮多边形波深增大而加剧。归纳提出以异常振动速度为切入点,对车轮多边形问题分析的仿真和线路实验方法。最后对直线电机悬挂参数进行优化,消除剧烈振动,提高了乘坐舒适性。
Abstract
Aiming at analysing the bad ride comfort caused by the nine-order polygon wheel of a domestic subway vehicle, numerical simulations and field tests were carried out. The reason of polygon wheel was analyzed theoretically. A dynamic model for the subway vehicle was established and the natural frequencies of bogie components were calculated. The simulations show that the vehicle ride comfort is irregularly bad at 40km/h. The transfer function from the track irregularity to the motor displacement was established and the results show that nine-order polygon wheels produce external excitation of 43Hz at 40km/h which is close to the vertical vibration natural frequency of the linear motor, causing the resonance of motor and the development of polygon wheel. The field tests show that the ride comfort tested on the car body is also irregularly bad at 40km/h and it tends to deterioration with the growth of polygon wave depth. The methods for simulations and field tests for studying polygon wheel effect, featured with the irregular vibration velocity as a key factor, were summarized. Finally, the parameters of motor suspension were optimized to eliminate the severe vibration and to improve the ride comfort.
关键词
直线电机 /
车轮多边形 /
共振 /
线路实验 /
传递函数 /
悬挂参数
{{custom_keyword}} /
Key words
linear motor /
polygonal wheel /
resonance /
field test /
transfer function /
suspension parameter
{{custom_keyword}} /
{{custom_sec.title}}
{{custom_sec.title}}
{{custom_sec.content}}
参考文献
[1]D.W Barke, W.K chiu. A review of the effects of out-of-round wheels on track and vehicle components[J].Journal of Rail and Rapid Transit.2005,219(F):151-175.
[2]J.C.O Nielsen,A Johansson.Out-of-round railway wheels-a literature survey[J]. Journal of Rail and Rapid Transit.2002,217(F2):79-91.
[3]吴磊,钟硕乔,金雪松,等.车轮多边形化对车辆运行安全性能的影响[J],交通工程运输学报,2011,11(3):47-54.
WU Lei,ZHONG Shuo-qiao,JIN Xue-song ,et al. Influence of polygonal wheel on running safety of vehicle[J]. Journal of Traffic and Transportation Engineering,2011,11(3):47-54.
[4] A.Johansson,C.Andersson.Out-of-round railway wheels—a study of wheel polygonalization through simulation of three-dimensional wheel–rail interaction and wear[J].Vehicle System Dynamics, 2005,43(8):539-559.
[5] 罗仁,曾京,邬平波等.高速列车车轮不圆顺磨耗仿真及分析[J],铁道学报,2010,32(5):30-35.
LUO Ren,ZENG Jing,WU Ping-bo,et al.Simulation and Analysis of Wheel Out-of-roundnessWear of High-speed Train[J].Journal of the China Railway Society. 2010,32(5):30-35.
[6] 陈光雄,金雪松,邬平波等.车轮多边形磨耗机理的有限元研究[J],铁道学报,2011,33(1):14-18.
CHEN Guang-xiong, JIN Xue-song, WU Ping-bo, et al.Finite Element Study on the Generation Mechanism of Polygonal Wear of Railway Wheels [J].Journal of Traffic and Transportation Engineering, 2011,33(1):14-18.
[7] Dr.B.Morys. Enlargement of Out-of-Round Wheel Profiles on High Speed Trains[J]. Journal of Sound and Vibration,1999,277(5):965-978.
[8] XuesongJin, Lei Wu,Jianying Fang, Shuoqiao Zhong, et al.An Investigation into the mechanism of the polygonal wear of metro train wheels and its effect on the dynamic behavior of a wheel/rail system[J].Vehicle System Dynamics, 2012, 50(12):1817-1834.
[9]马卫华,罗世辉,宋荣荣.地铁车辆车轮多边形化形成原因分析[J],机 械工程学报,2012,48(24):106-111.
MA Wei-hua,LUO Shi-hui,SONG Rongrong. Analyses of the Form Reason of Wheel Polygonization of Subway Vehicle[J].Journal of Mechanical Engineering,2012,48(24):106-111.
[10]王福天,车辆系统动力学[M].北京:中国铁道出版社,1992:152-153
[11]漆瑾.直线电机车辆转向架的研制与优化[J].机车电传动.2015,6:53-56.
QI Jin. Development and Optimization of Linear Motor Vehicle Bogie[J]. Electric Drive for Locmotives. 2015,6:53-56.
[12]李春胜,罗世辉,马卫华.基于频率响应函数的HXN3司机室隔振性能分析[J].振动与冲击.2013,32(19):210-215.
LI Chun-sheng, LUO Shi-hui, MA Wei-hua. Vibration isolation performance analysis of a HXN3 diesel locomotive cab based on frequency response functions[J].Journal of vibration and shock. 2013,32(19):210-215.
[13]廖英英,刘永强,杨绍普.一种新型混合半主动控制策略在高速铁道车辆振动控制中的应用[J]. 振动与冲击.2013,32(12):84-87.
LIAO Ying-ying, LIU Yong-qiang, YANG Shao-pu, A new mixed semi-active control strategy and its application in vibration control of a high-speed railway vehicle. Journal of vibration and shock. 2013,32(12):84-87.
{{custom_fnGroup.title_cn}}
脚注
{{custom_fn.content}}