斜撑式超越离合器二轴总成动态性能分析

PDF(1631 KB)

振动与冲击 ›› 2018, Vol. 37 ›› Issue (20) : 159-165.

论文

斜撑式超越离合器二轴总成动态性能分析

刘志辉 1，2，3 ，严宏志 1，3，曹煜明 1，3

作者信息 +

An analysis of dynamic performance of sprag one-way clutch two shafts assembly

LIU Zhihui 1,2,3 YAN Hongzhi 1,3, CAO Yuming 1,3

Author information +

文章历史 +

摘要

为使斜撑式超越离合器二轴总成具有良好的动态性能，采用集中参数法建立了四自由度横−扭耦合动力学模型，并运用龙格-库塔法对此非线性系统进行了数值求解，分别研究了斜撑式超越离合器扭转刚度和扭转阻尼对齿轮动态传递误差和动载荷的影响，以及齿轮重合度对斜撑式超越离合器动态溜滑角、最大冲击力及稳态接触力的影响。研究结果表明：1）系统在较低的激励频率范围内，齿轮动态传递误差和动载荷随离合器扭转刚度增大而减小，而在较高的激励频率范围内变化相反；2）齿轮动态传递误差和动载荷随斜撑式超越离合器扭转阻尼增大而减小；3）斜撑式超越离合器动态溜滑角、最大冲击力、稳态接触力随齿轮重合度增大而增大。

Abstract

In order to ensure the sprag one-way clutch two shafts assembly have good dynamic performance, a four-degree of freedom lateral-torsional coupling dynamic model was established by the lumped parameter method.The method of Runge Kutta was used to solve the nonlinear dynamic system equations.The effect of the sprag one-way clutch torsional stiffness and torsional damping on the dynamic transmission error and dynamic load of the gear pair was studied.And the effect of the contact ratio of the gear pair on the dynamic windup angle, the maximum impact force and the steady contact force of the sprag one-way clutch was studied also.The results show that: ① The dynamic transmission error and the meshing force of the gear pair decreases with the sprag one-way clutch torsional stiffness at the lower range of excitation frequencies, and it is vice verse at the higher range of excitation frequencies.② The dynamic transmission error and the meshing force of the gear pair decreases with the sprag one-way clutch torsional damping.③ The dynamic windup angle, the maximum contact force, the steady contact force of the sprag one-way clutch increases the contact ratio of the gear pair.

导出引用

刘志辉 1，2，3,严宏志 1，3，曹煜明 1，3. 斜撑式超越离合器二轴总成动态性能分析[J]. 振动与冲击, 2018, 37(20): 159-165

LIU Zhihui 1,2,3 YAN Hongzhi 1,3, CAO Yuming 1,3 . An analysis of dynamic performance of sprag one-way clutch two shafts assembly[J]. Journal of Vibration and Shock, 2018, 37(20): 159-165

参考文献

[1] Parker R G, Vijayakar S M, Imajo T. Non-Linear Dynamic Response Of a Spur Gear Pair: Modelling And Experimental Comparisons [J]. Journal of Sound and Vibration, 2000, 237(3): 435−455.
[2] Al-shyyab A, Kahraman A. Non-linear dynamic analysis of a multi-mesh gear train using multi-term harmonic balance method: period-one motions [J]. Journal of Sound and Vibration, 2005, 284(1−2): 151−172.
[3] Wang J, Lim T C, Li M. Dynamics of a hypoid gear pair considering the effects of time-varying mesh parameters and backlash nonlinearity [J]. Journal of Sound and Vibration, 2007, 308(1−2): 302−329.
[4] He S, Gunda R, Singh R. Effect of sliding friction on the dynamics of spur gear pair with realistic time-varying stiffness [J]. Journal of Sound and Vibration, 2007, 301(3−5): 927−949.
[5] Chen S Y, Tang J Y, Luo C W. Nonlinear dynamic characteristics of geared rotor bearing systems with dynamic backlash and friction [J]. Mechanism and Machine Theory, 2011, 46(4): 466−478.
[6] Li S, Kahraman A. A tribo-dynamic model of a spur gear pair [J]. Journal of Sound and Vibration, 2013, 332(20): 4963−4978.
[7] Liu X Z, Yang Y H, Zhang J. Investigation on coupling effects between surface wear and dynamics in a spur gear system [J]. Tribology International, 2016, 101: 383−394.
[8] Liu Z X, Liu Z S, Zhao J M, Zhang G H. Study on interactions between tooth backlash and journal bearing clearance nonlinearity in spur gear pair system [J]. Mechanism and Machine Theory, 2017, 107：229−245.
[9] Sainte-Marie N, Velex P, Roulois G, Caillet J. A Study on the Correlation Between Dynamic Transmission Error and Dynamic Tooth Loads in Spur and Helical Gears [J]. Journal of Vibration and Acoustics, 2016, 139(1): 011001−011010.
[10] Wang Guangjian C L, Yu Li. Research on the dynamic transmission error of a spur gear pair with eccentricities by finite element method [J]. Mechanism and Machine Theory, 2017, 109：1−13.
[11] 张旭东，高秀峰，郁永章.一种新型转子压缩机的内外转子啮合力分析[J].西安交通大学学报, 2002, 36(11): 1204−1207.
     ZHANG Xudong, GAO Xiufeng, YU Yongzhang. Theoretical analysis of meshing force on teeth in a new type     of rotary compressor [J].Journal of Xi’an Jiao Tong     University, 2002, 36(11): 1204−1207.
[12] 陈安华，罗善明，王文明，等.齿轮系统动态传递误差和振动稳定性的数值研究[J].机械工程学报, 2004, 40(4): 21−25.
     CHEN Anhua, LUO Shanming, WANG Wenming, et al.Numerical investigations on dynamic transmission error and stability of a geared rotor-bearing system [J].Chinese Journal of Mechanical Engineering, 2004, 40(4): 21−25.
[13] 毕凤荣，崔新涛，刘宁.渐开线齿轮动态啮合力计算机仿真[J].天津大学学报, 2005, 38(11): 991−995.
     BI Fengrong, CUI Xintao, LIU Ning. Computer simulation for dynamic meshing force of involute gears [J].Journal of Tianjing University, 2005, 38(11): 991−995.
[14] 刘辉，蔡仲昌，项昌乐.发动机激励下行星传动非线性啮合力特性[J].振动、测试与诊断, 2014, 34(1): 83−89.
     LIU Hui, CAI Zhongchang, XIANG Changle. Study on nonlinear meshing force dynamic behavior of planetary gears on engine excitation [J].Journal of vibration, Measurement ＆ Diagnosis, 2014, 34(1): 83−89.
[15] 刘辉，蔡仲昌，项昌乐.两级行星齿轮传动非线性啮合力频率耦合与动态特性研究[J].振动与冲击, 2015, 34(19): 13−23.
     LIU Hui, CAI Zhongchang, XIANG Changle. Frequency coupling and dynamic characteristics of nonlinear meshing force for two-stage planetary gears [J].Journal of Shock and Vibration,2015, 34(19): 13−23.
[16] 张义民，路金昌，胡鹏.转速及扭矩对啮合齿轮副非线性特性影响分析[J].东北大学学报（自然科学版）,2014, 35(3): 397−401.
     ZHANG Yimin, LU Jinchang, HU Peng. Non-linear characteristics analysis of gear pairs with the impact of rotational speed and torque [J].Journal of Northeastern University (Natural Science),2014, 35(3): 397−401.
[17] 冯海生，王黎钦，郑德志，等.考虑变工况冲击的齿轮动态啮合力分析[J].振动、测试与诊断, 2015, 35(2): 212−217.
     FENG Haisheng, WANG Liqin, ZHENG Dezhi, et al. Analysis of gear dynamic meshing force considering variable condition impact [J].Journal of vibration, Measurement ＆ Diagnosis, 2014, 34(1): 83−89.
[18] Walha L, Fakhfakh T, Haddar M. Nonlinear dynamics of a two-stage gear system with mesh stiffness fluctuation, bearing flexibility and backlash[J]. Mechanism and Machine Theory, 2009, 44(5): 1058-1069.
[19] Cheon G J. Nonlinear behavior analysis of spur gear pairs with a one-way clutch [J]. Journal of Sound and Vibration, 2007, 301(3-5): 760-776.
[20] Xu T. A mathematical model of an over-running sprag clutch [J]. Mechanism and Machine Theory, 1994, 29(1): 11-23.