基于响应面法的槽形梁结构噪声优化研究

刘林芽1,秦佳良1,雷晓燕1,刘全民1,宋瑞1,2

振动与冲击 ›› 2018, Vol. 37 ›› Issue (20) : 56-60.

PDF(1236 KB)
PDF(1236 KB)
振动与冲击 ›› 2018, Vol. 37 ›› Issue (20) : 56-60.
论文

基于响应面法的槽形梁结构噪声优化研究

  • 刘林芽1,秦佳良1,雷晓燕1,刘全民1,宋瑞1,2
作者信息 +

A study on optimization of the structure-borne noise from a trough girder based on response surface methodology

  • LIU Linya1, QIN Jialiang1, LEI Xiaoyan1,LIU Quan1, SONG Rui1,2
Author information +
文章历史 +

摘要

轨道交通槽形梁结构在列车动载作用下会辐射低频噪声,这种低频噪声对人体健康危害很大。以轨道交通30m简支槽形梁为研究对象,基于车桥耦合分析模型,利用有限元法和边界元法计算槽形梁结构辐射声功率。将响应面法与辐射声功率计算相结合,建立了以槽形梁辐射结构噪声在分析频率范围内的总声功率级为目标及以槽形梁质量为约束的声学优化模型,再利用序列二次规划法进行求解,最终找出了槽形梁结构声学最优的截面尺寸。优化后槽形梁底板厚度为0.34m,腹板厚度为0.22m。计算结果表明,利用响应面法可以有效的对槽形梁进行声学优化,而且优化后的降噪效果还是比较显著的。

Abstract

The low frequency noise radiated by a trough girder under the dynamic load of trains is very harmful to human health.Taking a 30-m simply-supported trough girder for rail transit as the research object, based on the vehicle-bridge coupling analysis model, the sound power of rail transit trough girder was calculated by using the finite element method and the boundary element method.Then the response surface methodology and the calculation of sound power were combined, acoustic optimization model was established which takes total sound power in the range of analyzing frequency of the trough girder as the target and the quality of the trough girder as the constraint.Finally, the sequential quadratic programming was used to obtain the optimum section size of the trough girder.The thickness of the deck is 0.34m and the thickness of the web is 0.22m after acoustic optimization of trough girder.The results show that the response surface methodology can effectively optimize the structure-borne noise from a trough girder, and the effect of noise reduction is still significant after the optimization.

关键词

槽形梁 / 有限元法 / 边界元法 / 结构噪声 / 响应面法 / 声学优化

Key words

trough girder / finite element method / boundary element method / structure-borne noise / response surface methodology / acoustic optimization

引用本文

导出引用
刘林芽1,秦佳良1,雷晓燕1,刘全民1,宋瑞1,2. 基于响应面法的槽形梁结构噪声优化研究[J]. 振动与冲击, 2018, 37(20): 56-60
LIU Linya1, QIN Jialiang1, LEI Xiaoyan1, LIU Quan1, SONG Rui1,2. A study on optimization of the structure-borne noise from a trough girder based on response surface methodology[J]. Journal of Vibration and Shock, 2018, 37(20): 56-60

参考文献

[1] 刘加华,练松良. 城市轨道交通振动与噪声[J]. 交通运输工程学报,2002(1):29-33.
LIU Jia-hua, LIAN Song-liang. Vibration and noise of the urban rail transit[J]. Journal of Traffic and Transportation Engineering, 2002(1):29-33.
[2] Ngai K W, C. F N G. Structure-Borne Noise and Vibration of Concrete Box Structure and Rail Viaduct[J]. Journal of Sound & Vibration, 2002, 255(2):281-297.
[3] Møller H, Pedersen C S. Low-frequency noise from large wind turbines[J]. Journal of the Acoustical Society of America, 2011, 129(6):3727-3744.
[4] 高飞,夏禾,安宁. 北京地铁5号线高架结构的辐射噪声分析与实验研究[J]. 中国铁道科学,2010(5):134-139.
GAO Fei, XIA He, AN Ning. Analysis and experimental study on the radiation noise of the elevated structures of Beijing metro line 5[J]. China Railway Science, 2010(5):134-139.
[5] CROCKETT A R, PYKE J. Viaduct Design For Minimization of Direct and Structure-radiated Train Noise[J]. Journal of Sound and Vibration, 2000, 231(3):883-897.
[6] Zhang X, Li X Z, Liu Q M, et al. Theoretical and experimental investigation on bridge-borne noise under moving high-speed train[J]. Science China Technological Sciences, 2013, 56(4):917-924.
[7] 张迅,李小珍,刘全民,等.混凝土箱梁的结构噪声及其影响因素[J]. 西南交通大学学报,2013,48(3):409-414.
ZHANG Xun, LI Xiaozhen, LIU Quanmin, et al. Structure-Borne Noise of Concrete Box-Girder and Its Influence Factors[J]. Journal of Southwest Jiaotong University, 2013, 48(3): 409-414.
[8] 韩江龙,吴定俊,李奇.板厚和加肋对槽型梁结构噪声的影响[J].振动工程学报,2012, (05):589-594.
HAN Jiang-long, WU Ding-jun, LI Qi. Influence of deck thickness and stiffeners on structure-borne noise of the trough beams[J]. Journal of Vibration Engineering, 2012, (05): 589-594.
[9] Bewes O G. The calculation of noise from railway bridges and viaducts [D]. Southampton: University of Southampton, 2005.
[10] 刘林芽,许代言.腹板开孔的箱型梁结构噪声辐射特性分析[J].振动与冲击, 2016, 35(15):204-210.
LIU Linya, XU Daiyan. Structural noise radiation characteristics of box beams with web holes[J]. Journal of Vibration and Shock, 2016, 35(15): 204-210.
[11] 李克冰,张楠,夏禾,苏伟,张雷,马广.高速铁路32m简支槽形梁桥结构噪声分析[J]. 中国铁道科学,2015,04:52-59.
LI Kebing, ZHANG Nan, XIA He, SU Wei, ZHANG Lei, MA Guang. Analysis on structure-borne noise of 32m simply-supported trough girder bridge for high speed railway [J]. China Railway Science, 2015, 04: 52-59.
[12] 华洪良,廖振强,邱明,等.基于网格变形技术的机枪三脚架多目标响应面优化[J].振动与冲击, 2015, 34(16): 141-146.
HUA Hong-liang, Liao Zhen-qiang, Qiu Ming, et al. Multi-objective optimization combining response surface model of machine gun tripod based on mesh morphing technology[J]. Journal of Vibration and Shock, 2015,34(16): 141-146.

PDF(1236 KB)

Accesses

Citation

Detail

段落导航
相关文章

/