重载铁路钢轨磨耗分布发展计算模型及影响因素研究

PDF(3331 KB)

振动与冲击 ›› 2018, Vol. 37 ›› Issue (24) : 72-79.

论文

王璞，王树国

作者信息 +

A study on the calculation model and influence factors of rail wear distribution for heavy haul railway

WANG Pu，WANG Shuguo

Author information +

文章历史 +

摘要

建立了钢轨磨耗数值计算模型，可实现磨耗具体分布及发展的定量预测分析。对货车轴重、速度及材料硬度对钢轨磨耗分布发展的影响进行了系统研究，弥补了既有研究多采用定性指标、无法定量分析对磨耗分布发展的影响的不足。主要结论：1）轴重影响：直线运行时，随轴重的增加钢轨磨耗均呈马鞍状分布且马鞍状特征愈发显著，波峰磨耗深度逐渐增大而波谷磨耗深度逐渐减小，磨耗量总体呈增大趋势。曲线运行时两轨磨耗分布差异较大，随轴重的增加钢轨磨耗分布特征保持一致，幅值呈增大趋势。2）速度影响：直线运行时，随车速的提高钢轨磨耗向轨头内侧扩展加宽，分布区域磨耗深度均呈增大趋势。曲线运行时，随车速的提高外轨轨肩磨耗幅值先减小后增大而轨顶磨耗变化较小，内轨磨耗明显下降。相对轴重而言车速对磨耗的影响更显著，从减磨角度同等条件下宜优先发展大轴重货车来实现扩能增效，并尽量减少重车方向大幅提速。3）材料硬度影响：增大轮轨硬度对磨耗分布区域和形状影响不明显，但可显著降低磨耗幅值和磨耗量。但硬度过高易加速疲劳伤损，不一定能延长使用寿命。

Abstract

A numerical model was established, which can predict the wear distribution and development quantificationally.The influences of axle load, running speed and material hardness on rail wear distribution and development were studied systematically.This work solves the problems of lacking quantitative analysis in previous research.The major conclusions are as follows.① Influences of axle load: in the tangent section, with the axle load increasing, the rail wear are all distributed like saddle and the saddle feature becomes more obvious.The crest wear depth increases and the trough wear depth decreases.The wear loss tends to increase as a whole.In the curved section, the wear distribution is significantly different between the two rails.With the axle load increasing, the rail wear distribution characteristics remain almost the same, and the magnitude tends to increase.② Influences of speed: in the tangent section, with the vehicle speed increasing, the rail wear extends towards the inner side, and the wear depth increases over the distribution zone.In the curved section, with the speed increasing, the wear magnitude around the shoulder of outer rail decreases firstly and then increases, while the wear magnitude on the top of outer rail changes slightly.The wear magnitude of the inner rail decreases obviously.Compared with axle load, the influence of vehicle speed on wear is more significant.From the perspective of slowing down wear, priority should be given to developing heavy-axle load freight vehicle to expand the capacity of the heavy haul railway.Meanwhile, the speed of loaded vehicle should not be increased greatly.③ Influences of material hardness: Increasing the hardness will not influence the wear distribution zone and shape significantly, but can reduce the wear magnitude notably.However, excessive high hardness will accelerate fatigue damage and may not prolong the life-span of rail.

导出引用

王璞，王树国. 重载铁路钢轨磨耗分布发展计算模型及影响因素研究[J]. 振动与冲击, 2018, 37(24): 72-79

WANG Pu，WANG Shuguo. A study on the calculation model and influence factors of rail wear distribution for heavy haul railway[J]. Journal of Vibration and Shock, 2018, 37(24): 72-79

参考文献

[1] J. De Arizon, O. Verlinden, P. Dehombreux. Prediction of wheel wear in urban railway transport: comparison of existing models [J]. Vehicle System Dynamics, 2007, 45(9): 849-874.
[2] 熊嘉阳, 邓永权, 曹亚博等. 重载铁路轮轨磨耗及其对安全运行的影响[J]. 西南交通大学学报, 2014(2): 302-309.
Xiong Jiayang, Deng Yongquan, Cao Yabo, et al. Wheel-rail wear on heavy haul lines and its influences on running stability of trains [J]. Journal of Southwest Jiaotong University, 2014(2): 302-309.
[3] 李霞, 金学松, 胡东等. 车轮磨耗计算模型及其数值方法[J]. 机械工程学报, 2009, 45(9): 193-200.
Li Xia, Jin Xuesong, Hu Dong, et al. Theoretical model and numerical method of wheel profile wear[J]. Journal of Mechanical Engineering, 2009, 45(9): 193-200.
[4] Zobory I. Prediction of wheel/rail profile wear [J]. Vehicle System Dynamics, 1997(28): 221-259.
[5] 俞展猷. 轮轨磨耗机理与轮轨润滑[J]. 铁道机车车辆, 2000(5): 11-14.
Yu Zhanyou. Wheel-rail wear and wheel-rail lubricate [J]. Railway Locomotive & Car, 2000(5): 11-14.
[6] 阎国臣, 何庆复, 高义刚等. 车轮磨损失效研究[J]. 铁道物资科学管理, 2002, 20(2): 26-28.
Yan Guochen, He Qingfu, Gao Yigang, et al. Failure research of wheel wear [J]. Railway Materials Management, 2002, 20(2): 26-28.
[7] 邵朋朋, 傅茂海, 周元等. 基于Archard模型的重载铁路货车车轮磨耗研究[J]. 铁道机车车辆, 2012, 32(2): 42-45, 57.
Shao Pengpeng, Fu Maohai, Zhou Yuan, et al. Research on the evaluation of wheel-rail wear of heavy haul railway based on Archard's model [J]. Railway Locomotive & Car, 2012, 32(2): 42-45, 57.
[8] 陈鹏, 高亮, 郝建芳等. 铁路曲线上轮轨磨耗影响参数的仿真研究[J]. 中国铁道科学, 2007, 28(5): 19-23.
Chen Peng, Gao Liang, Hao Jianfang, et al. Simulation study on parameters influencing wheel/rail wear in railway curve [J]. China Railway Science, 2007, 28(5): 19-23.
[9] 李亨利. 货车径向转向架动力学特性及轮轨磨耗研究[D]. 西南交通大学, 2006.
[10] 周素霞, 薛蕊. 地铁线路超高对轮轨磨耗的影响[J]. 北京交通大学学报, 2015, 39(1): 101-107.
Zhou Suxia, Xue Rui. Influence of superelevation of subway line act on wheel-rail wear [J]. Journal of Beijing Jiaotong University, 2015, 39(1): 101-107.
[11] 张良威. 重载货车轮轨磨耗研究[D]. 西南交通大学, 2008.
[12] Archard J F. Contact and rubbing of flat surfaces [J]. Journal of Applied Physics, 1953(24): 981-988.
[13] Jendel T. Prediction of wheel profile wear-comparisons with field measurements [J]. Wear, 2002, 253: 89-99.
[14] 马腾, 朱桂兰. 热处理钢轨的轨/轮匹配关系研究[J]. 物理测试, 1999, (5): 1-3.
Ma Teng, Zhu Guilan. Study on matching relationship between rail and wheel [J]. Physics Examination and Testing, 1999, (5): 1-3.