叶轮时序对多级泵振动特性影响的试验测试

PDF(1189 KB)

振动与冲击 ›› 2020, Vol. 39 ›› Issue (3) : 1-7.

论文

叶轮时序对多级泵振动特性影响的试验测试

谈明高1，廉益超1，吴贤芳2，刘厚林1

作者信息 +

Tests for effects of impeller timing on vibration characteristics of a multi-stage centrifugal pump

TAN Minggao1, LIAN Yichao1, WU Xianfang2, LIU Houlin1

Author information +

文章历史 +

摘要

叶轮时序效应对于旋转机械的振动性能有着重要的影响。以实验测试研究了叶轮时序效应对一台五级离心泵振动特性的影响。采用正交设计方法设计了8个实验方案，在多级泵5个不同位置进行振动特性的测量，包括进口轴向、进口出口的水平和垂直方向。结果表明，时序效应对多级泵水平方向上振动的影响大于垂直方向上振动的影响，所有测点的振动谐频都位于1×fn、2×fn、3×fn 和4×fn。叶轮时序效应对每个谐频幅值都存在重要的影响，在不同的方案下，1×fn、2×fn、3×fn 和4×fn上幅值的最大变化可达17.7%、10.0%、33.2%和47.4%。对比各方案，发现调整第二和第三泵级叶轮的时序位置，可以获得较好的整泵振动特性。

Abstract

Impeller timing effect has an important influence on vibration performance of rotating machineries.Here, effects of impeller timing on vibration characteristics of a five-stage centrifugal pump were investigated with tests.8 test schemes were designed with the orthogonal design method, Vibration characteristics measurements were done at 5 different positions of the pump including its inlet axial direction, horizontal and vertical directions of its inlet and outlet.The test results showed that the influence of impeller timing effect on the pump’s vibration in horizontal direction is bigger than that in vertical direction, all measured points’ resonance frequencies are at 1×fn, 2×fn, 3×fn and 4×fn; impeller timing effect affects all resonant amplitudes significantly, the maximum variations of resonant amplitudes at 1×fn, 2×fn, 3×fn and 4×fn under different test schemes are 17.7%, 10.0%, 33.2% and 47.4%, respectively; comparing the results of 5 test schemes reveals adjusting timing positions of the 2nd and 3rd stage impellers of the pump can obtain better vibration characteristics of the whole pump.

导出引用

谈明高1，廉益超1，吴贤芳2，刘厚林1. 叶轮时序对多级泵振动特性影响的试验测试[J]. 振动与冲击, 2020, 39(3): 1-7

TAN Minggao1, LIAN Yichao1, WU Xianfang2, LIU Houlin1. Tests for effects of impeller timing on vibration characteristics of a multi-stage centrifugal pump[J]. Journal of Vibration and Shock, 2020, 39(3): 1-7

参考文献

[1] Walker G J, Oliver A R. The Effect of Interaction Between Wakes From Blade Rows in an Axial Flow Compressor on the Noise Generated by Blade Interaction[J]. Journal of Engineering for Gas Turbines & Power,1972, 94(4): 241-248.
[2] Cizmas P G, Dorney D J. Parallel computation of turbine blade clocking[R]. AIAA Paper 98-3598, 1998.
[3] Wo A M. Reduction of Unsteady Blade Loading by Beneficial Use of Vertical and Potential Disturbances in an Axial Compressor With Rotor Clocking[J]. Journal of Turbomachinery, 1998, 120(4): 705-713.
[4] Sharma O P. Unsteady Flow in Turbines-Impact on Design[R]. AGARD Lecture serious 195.1994.
[5] Arnone A. Numerical investigation of Airfoil Clocking in a Three-Stage Low-Pressure Turbine[J]. Journal of Turbomachinery, 2002, 124(1): 61-68.
[6] Du H J, Hu J, Yao G. Numerical simulation of clocking effect in reducing rotor blade unsteady aerodynamic force [J]. Gas Turbine Experiment & Research, 2007, 20(1) : 21-26.
[7] Zhao B, Yang C, Li D, et al. The study of the effect of interference frequency and clocking position on the stationary blade wake [J]. Journal of Engineering Thermophysics, 2013, 34(2) : 245-248.
[8] 袁寿其，施卫东，刘厚林. 泵理论与技术[M]. 北京：机械工业出版社， 2014.
Yuan S Q, Shi W D, Liu H. L, et al. Theory and technology of pump[M]. Beijing: China Machine Press, 2014.
[9] 朱相源, 江伟, 李国君,等. 导叶与隔舌相对位置对离心泵非定常压力脉动影响的数值模拟[J]. 排灌机械工程学报, 2015, 33(10):829-834.
ZHU Xiangyuan，JIANG Wei，LI Guojun，et al. Numerical investigation into influence of installation location between diffuser vane and volute tongue on unsteady pressure fluctuations in centrifugal pump with vane diffuser［J］. Journal of Drainage and Irrigation Machinery Engineering, 2015, 33( 10) : 829 -834．
[10] Qu W, Tan L, Cao S, et al. Numerical investigation of clocking effect on a centrifugal pump with inlet guide vanes[J]. Engineering Computations, 2016, 33(2):465-481
[11] Jiang W, Li G, Liu P F, et al. Numerical investigation of influence of the clocking effect on the unsteady pressure fluctuations and radial forces in the centrifugal pump with vaned diffuser[J]. International Communications in Heat & Mass Transfer, 2016, 71:164-171.
[12] Xu Yun, Tan Lei, Cao Shuliang, Qu Wanshi. Multiparameter and multiobjective optimization design of centrifugal pump based on orthogonal method [J]. Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science. 2017, 231(14): 2569–2579.
[13] Liu M, Tan L, Cao S. Design Method of Controllable Blade Angle and Orthogonal Optimization of Pressure Rise for a Multiphase Pump[J]. Energies, 2018, 11(5).
[14] Zhu X Y, Jiang W, Li G J, et al. Numerical investigation into influence of installation location between diffuser vane and volute tongue on unsteady pressure fluctuations in centrifugal pump with vane diffuser [J]. Journal of Drainage and Irrigation Machinery Engineering, 2015, 33(10): 829-834.
[15] 王宁, 黄彪, 吴钦,等. 绕水翼空化流动及振动特性的试验与数值模拟[J]. 排灌机械工程学报, 2016，34(4)：321-327.
Wang Ning, Huang Biao, Wu Qin, et al. Experiment and numerical simulation of vibration characteristics of hydrofoil in cavitation flow[J]. Journal of Drainage and Irrigation Machinery Engineering, 2016, 34(4):321-327.
[16] 谈明高, 戴菡葳, 刘厚林,等. 多级离心泵叶轮时序对振动性能影响的数值研究[J]. 振动与冲击, 2015, 34(24):117-122.
TAN Minggao, DAI Hangwei, LIU Houlin, et al. Numerical simulation on the effect of impeller clocking position on vibration of multistage centrifugal pumps[J]. Journal of Vibration and shock, 2015, 34(24):117-122.
[17] 高品贤. 振动、冲击及噪声测试技术[M]. 成都：西南交通大学出版社, 1992.
GAO PinXian. Testing technology of vibration, shock and noise [M]. Chendu: Southwest Jiaotong University Press，1992.
[18] Li J B. The discussion of using RMS to represent based vibration intensity of reciprocating piston compressor [J]. Industrial Construction, 1992(6): 50-51.
[19] Robert C E. Machinery Malfunction Diagnosis and Correction: Vibration Analysis and Troubleshooting for the Process Industries [M]. Englewood: Prentice Hall PTR, 1997.
[20] Morgenroth M, Weaver D S. Sound generation by a centrifugal pump at blade passing frequency [J]. Journal of Turbomachinery, 1998, 120(4):736-743.