新型轴向磁气组合轴承性能研究

PDF(2014 KB)

振动与冲击 ›› 2021, Vol. 40 ›› Issue (16) : 45-52.

论文

新型轴向磁气组合轴承性能研究

陈李成，谢振宇，吴炎，郝建胜

作者信息 +

A study on the performance of a new type axial magnetic-gas bearing

CHEN Licheng，XIE Zhenyu，WU Yan，HAO Jiansheng

Author information +

文章历史 +

摘要

将螺旋槽型动压气体止推轴承(spiral groove gas bearing，SGGB)与主动磁轴承相结合，搭建了轴向磁气组合轴承转子系统试验台。通过仿真分析，研究了槽深、槽数、槽宽比、槽端半径比和螺旋角等结构参数对螺旋槽型动压气体止推轴承承载力的影响。通过高速旋转试验，研究了螺旋槽型动压气体止推轴承的实际承载力和系统的动态性能。通过跌落试验，验证了螺旋槽型动压气体止推轴承作为轴向保护轴承的可行性。研究结果表明，引入螺旋槽型动压气体止推轴承，有助于提高系统的动态性能，当轴向磁轴承失效时，可减轻转子直接撞击造成的损害。

Abstract

With the combination of spiral groove gas bearing (SGGB) and active magnetic bearing, a rotor system test-bed of axial magnetic-gas bearing was built.Through simulation analysis, the effects of structural parameters of the SGGB on the bearing capacity were studied, such as groove depth, groove number, groove width ratio, groove end radius ratio and spiral angle.Through the high-speed rotation test, the actual bearing capacity of the SGGB and the dynamic performance of the system were studied.Through the drop test, the feasibility of the SGGB as axial protection bearing was verified.The research results show that the SGGB can improve the dynamic performance of the system and can reduce the damage caused by the direct impact of the rotor when the axial magnetic bearing fails.

导出引用

陈李成，谢振宇，吴炎，郝建胜. 新型轴向磁气组合轴承性能研究[J]. 振动与冲击, 2021, 40(16): 45-52

CHEN Licheng，XIE Zhenyu，WU Yan，HAO Jiansheng. A study on the performance of a new type axial magnetic-gas bearing[J]. Journal of Vibration and Shock, 2021, 40(16): 45-52

参考文献

［1］魏鹏,王云峰,杨勇,等.高速悬浮转子跌落在保护轴承上的碰撞力研究［J］.振动与冲击，2018,37(20): 251-258.
WEI Peng, WANG Yunfeng, YANG Yong, et al.An analysis of the contact force between a floating rotor and a retainer bearing after rotor drop［J］.Journal of Vibration and Shock, 2018,37(20): 251-258.

［2］ZENG S.Motion of AMB rotor in back up bearings［J］.Journal of Vibration and Acoustics, 2002,124(3): 460-464.

［3］SWANSON E E, HESHMAT H, WALTON J.Performance of a foil-magnetic hybrid bearing［J］.Journal of Engineering for Gas Turbines and Power, 2002,124(2): 375-382.

［4］PHAM M N, AHN H J.Experimental optimization of a hybrid foil-magnetic bearing to support a flexible rotor［J］.Mechanical Systems and Signal Processing, 2014,46(2): 361-372.

［5］樊登柱,徐凡.高速永磁同步电动机用电磁-气体箔片混合轴承设计［J］.轴承, 2016(10): 4-9.
FAN Dengzhu, XU Fan.Design of electromagnetic-mixed gas foil bearings for high speed permanent magnet synchronous motor［J］.Bearing, 2016(10): 4-9.

［6］李媛媛.透平膨胀机磁气混合轴承特性研究［D］.北京：北京科技大学,2017.

［7］QIU Y, KHONSARI M M.Investigation of tribological behaviors of annular rings with spiralgroove［J］.Tribology International, 2011,44(12): 1610-1619.

［8］解志杰.轴向气磁复合轴承的理论及试验研究［D］.哈尔滨：哈尔滨工业大学,2009.

［9］王云飞.气体润滑理论与气体轴承设计［M］.北京:机械工业出版社, 1999.

［10］施威策尔，马斯伦.磁悬浮轴承：理论、设计及旋转机械应用［M］.徐旸，张凯，赵雷，译.北京：机械工业出版社，2012.

［11］胡业发,周祖德,江征风.磁力轴承的基础理论与应用［M］.北京:机械工业出版社,2006．

［12］侯予,陈纯正,王秉琛.平面螺旋槽动压止推气体轴承的设计［J］.润滑与密封,2002(1): 2-4.
HOU Yu, CHEN Chunzheng, WANG Bingchen.The design of gas-lubricated spiral grooved thrust bearings［J］.Lubrication Engineering, 2002(1): 2-4.

［13］BELFORTE G, RAPARELLI T, TRIVELLA A, et al.CFD analysis of a simple orifice type feeding system for aerostatic bearings［J］.Tribology Letters, 2015,58(2): 25.

［14］龙威,李军，包钢.FLUENT软件在空气轴承研究领域的应用［J］.机床与液压,2006(6): 151-153.
LONG Wei, LI Jun, BAO Gang.Application of FLUENT in the research of air bearing field［J］.Machine Tool and Hydraulics, 2006(6): 151-153.

［15］汪久根,陈芳华，陈李果，等.螺旋槽轴承研究综述［J］.润滑与密封，2017,42(3): 1-7.
WANG Jiugen, CHEN Fanghua, CHEN Liguo, et al.A review on groove bearings［J］.Lubrication Engineering, 2017,42(3): 1-7.