钢筋钢纤维混凝土梁柱节点模型化方法研究

薛茹,刘晨晨,赵雯桐,史科,张涛,管巧艳

振动与冲击 ›› 2022, Vol. 41 ›› Issue (2) : 96-102.

PDF(2340 KB)
PDF(2340 KB)
振动与冲击 ›› 2022, Vol. 41 ›› Issue (2) : 96-102.
论文

钢筋钢纤维混凝土梁柱节点模型化方法研究

  • 薛茹,刘晨晨,赵雯桐,史科,张涛,管巧艳
作者信息 +

Modeling method for steel fiber reinforced concrete beam column joints

  • XUE Ru,LIU Chenchen,ZHAO Wentong,SHI Ke,ZHANG Tao,GUAN Qiaoyan
Author information +
文章历史 +

摘要

为研究钢筋钢纤维混凝土梁柱节点抗震性能数值模拟方法,基于OpenSEES有限元平台中的Beam-Column Joint Element 模型,通过修正模型中剪切块和钢筋滑移弹簧的参数修正方法,提出适用于钢筋钢纤维混凝土梁柱节点的数值模型,并基于6个梁柱节点的拟静力试验结果进行模型验证分析,数值模拟结果与试验结果吻合较好,提出的数值模型能够较精确的反映节点滞回行为。在此基础上,分析了轴压比、钢纤维体积率和配箍量对梁柱节点抗震性能的影响规律,建立了节点受剪承载力的计算公式。结果表明:掺入钢纤维和增加配箍可明显改善梁柱节点的抗震性能,钢纤维体积率从0.5%增加到2.0%,极限荷载提高了18%;箍筋从1Φ8增加到3Φ8时,极限荷载提高了19.7%。

Abstract

Based on the OpenSEES standard solver, the objectives of this paper presented a numerical simulation method on investigating the seismic behavior of steel fiber reinforced concrete beam column joints through modifying the calculation method of shear deformation in the core area of joint and bond slip deformation of longitudinal reinforcement of beam. And then, a set of experimental data was collected to verify the accuracy of the numerical modeling approach, in terms of the hysteresis curves and skeleton curves. It can be found that the numerical simulationaccurate reflected the development of Beam-Column Joint., and thepredicted curves agreed well with theexperimental results. Furthermore, the influence of some key parameters on the seismic performance of Beam-Column Joint was investigated and discussed in detail, and a design formula for calculating the ultimate shear capacity was also established. Lastly, the parametric analysis clearly indicated that both adding thesteel fiber and increasing the stirrups ratio can significantly improve the seismic behavior of Beam-Column Joint. With the increase in volume ratio of steel fiber, the ultimate load was improved by 18%, respectively. Besides, the ultimate load was improved by 19.7%, with the increase of stirrup diameter.

关键词

梁柱节点 / 钢纤维混凝土 / 数值模拟 / OpenSEES

Key words

Beam column joints / Steel fiber reinforced concrete / Numerical simulation;OpenSEES

引用本文

导出引用
薛茹,刘晨晨,赵雯桐,史科,张涛,管巧艳. 钢筋钢纤维混凝土梁柱节点模型化方法研究[J]. 振动与冲击, 2022, 41(2): 96-102
XUE Ru,LIU Chenchen,ZHAO Wentong,SHI Ke,ZHANG Tao,GUAN Qiaoyan. Modeling method for steel fiber reinforced concrete beam column joints[J]. Journal of Vibration and Shock, 2022, 41(2): 96-102

参考文献

[1] 高丹盈,史科,赵顺波.钢筋钢纤维高强混凝土梁柱节点承载力计算方法[J].建筑结构学报, 2014,35(02):71-79.
GAO Danying, SHI Ke, ZHAO Shunbo. Calcul- ation method for bearing capacity of steel fiber reinforced high-strength concrete beam column joints[J].Journal of Building Structures,2014, 35 (02):71-79.
[2] 杨红,白绍良.考虑节点内梁纵筋粘结滑移的结构弹塑性地震反应[J].土木工程学报,2004(05):16-22.
YANG Hong, BAI Shaoliang. Elastoplastic Eart- hquake Response of Structure Considering Slipp- age between Longitudinal Steel Bar and Concrete of Beam in Nodes. [J].Journal of Civil Enginee- ring,2004(05):16-22.
[3] ALATH S, KUNNATH S K. Modeling inelastic shear deformation in RC beam-column joints[C]//Proceedings of 10th Conference on Enginee-ring Mechanics. Reston, VA: ASCE, 1995:822-825.
[4] FLEURY F,REYNOUARD J,MERABET  O. Multicomponent model of reinforced concrete joints for cyclic loading[J]. Journal of Engineeri-ng Mechanics, 2000, 126 (8) : 804-811.
[5] LOWES L N, ALTOONTASH A. Modeling reinforced concrete beam-column joints subject- ed to cyclic loading[J]. Journal of Structural Eng- ineering, 2003, 129 (12) : 1686-1697.
[6] MitraN,Lowes L N.Evaluation,calibration andver- ification of a reinforced concrete beam-column joint model[J].Journal of StructuralEngi- neering,2007,133(1):105-120.
[7] 赵雯桐,杨红,傅剑平,李戌.钢筋混凝土中间层边节点模型化方法研究[J].建筑结构学报,2018,39(S1):254-262.
ZHAO Wentong, YANG Hong, FU Jianping, LI Xu. Modelling of RC exterior beam-column joint [J]. Journal of Building Structures,2018,39 (S1): 254-262.
[8] MITRA N. An analytical study of reinforced concrete beam-column joint behavior under seismic loading[D]. Washington DC: University of Washington, 2007: 1-210.
[9] 史科. 钢筋钢纤维高强混凝土梁柱节点抗震性能及计算方法[D].郑州大学,2016.
SHI Ke. Seismic Behavior and Calculation Meth- od of Steel Fiber Reinforced High-Strength Con- crete Beam-Column Joints[D].Zhengzhou Unive- rsity,2016.
[10] 梁兴文,王英俊,邢朋涛,王海,邓明科.局部采用纤维增强混凝土梁柱节点抗震性能试验研究[J].工程力学,2016,33(04):67-76.
LIANG Xingwen, WANG Yingjun, XING Peng tao,  WANG Hai, DENG Mingke. Experimental Study on Seismic Performance of Beam-Column Joints with Fiber-Reinforced Concrete in Joint Core and Plastic Hinge Zone of Beam and Colu- mn [J]. Engineering Mechanics, 2016, 33(04): 67 -76.
[11] Menegotto M,Pinto P E. Method of analysis for cyclically loaded reinforced concrete plane frames including chan-ges in geometry and non-elastic behavior of elements under combined normal force and bending[C]//Proceedi-ngs of the Conference on Resistance and Ultimate Defo-rmability of Structures Acted on by Well Defined Repeated Loads. Lisbon:International Association for Bridge and Structural Engineering,1973:15-22
[12] Yassin M H M.Nonlinear analysis of prestressed concrete structures under monotonic and cyclic loads[D].Berkeley:University of California, 1994.
[13] MANDER J B, PRIESTLEY M J N, PARK R.Theoretical stress-strain model for confined concrete[J].Journal of Structural Engineering, ASCE, 1988, 114 (8) :1804-1826.
[14] Harajli M H, Gharzeddine O.Effect of steel fibers on bondperformance of steel bars in NSC and HSC under loadreversals[J].Journal of Materials in Civil Engineering, 2007, 19 (10) :864.
[15] M. A. Mansur, M. S. Chin, T. H. Wee. Stress-Strain Relationship of High-Strength Fiber Concrete in Compre- ssion[J]. Journal of Materials in Civil Engineering 1999, 11(1):21-29.
[16] Campione G, Cucchiara C, Mendola L L, et al.Experimentalinvestigation on local bond-slip behaviour in lightweight fiberreinforced concrete under cyclic actions[J].Proceeding of 13thWorld Conference on Earthquake Engineering.Vancou-ver:WCEE, 2004:2087.
[17] Mazzoni S, Mckenna F and Scott M H. OpenS- ees users manual[R]. University of California, Berkeley, 2006.
[18] Harajli M H.Bond behavior in steel fiber-reinforced concretezones under static and cyclic loading:experimental evaluationsand analytical modeling =[J].Journal of Materials in CivilEngineerin- g,2010,22 (7) :674.
[19] Paulay T, Priestley M N J. Seismic design of reinforced concrete and masonry building[M].New York: John Wiley&Sons,1992.
[20] GB50010-2010 混凝土结构设计规范[S]. 北京: 中国建筑工业出版社, 2010.
GB50010-2010Design Code for Concrete Structures[S]. Beijing: China Building Industry Press,2010.

PDF(2340 KB)

Accesses

Citation

Detail

段落导航
相关文章

/