考虑支点变形和摩擦的可倾瓦轴承动力学特性研究

金英泽1,袁小阳2

振动与冲击 ›› 2022, Vol. 41 ›› Issue (20) : 61-67.

PDF(2047 KB)
PDF(2047 KB)
振动与冲击 ›› 2022, Vol. 41 ›› Issue (20) : 61-67.
论文

考虑支点变形和摩擦的可倾瓦轴承动力学特性研究

  • 金英泽1,袁小阳2
作者信息 +

Dynamic characteristic analysis of tilting-pad journal bearings considering deformation and friction of pivot

  • JIN Yingze1,YUAN Xiaoyang2
Author information +
文章历史 +

摘要

针对球形支点可倾瓦轴承(tilting-pad journal bearing ,TPJB)瓦块与支点滑动接触问题,采用紊流雷诺方程、赫兹接触理论和库伦摩擦定律建立了考虑支点弹性力和摩擦力矩的可倾瓦轴承系统非线性动力学模型和分析方法,研究了支点变形和摩擦对水润滑可倾瓦轴承轴心轨迹、瓦块振动响应和最小液膜厚度等动力学特性的影响,揭示了支点半径比和支点摩擦系数对轴承性能的影响规律。结果表明:支点变形可使系统振幅和最小膜厚皆增大;支点摩擦可使系统振幅减小,对最小膜厚影响较小且与动载大小有关;增大支点半径比和支点摩擦系数有利于降低系统振幅;当支点半径比为0.96~0.97、支点摩擦系数为0~0.15时,轴承有较高的承载能力。研究结果对球形支点可倾瓦轴承精确建模和优化设计有参考价值。
关键词:可倾瓦轴承;支点变形;支点摩擦;动力学特性

Abstract

Aiming at the sliding contact problem between pad and pivot of spherical-pivot tilting-pad journal bearing (TPJB), a nonlinear dynamic model and analysis method of TPJB system considering the elastic force and friction torque of pivot were established using turbulent Reynolds equation, Hertz contact theory and Coulomb friction law. The effects of pivot deformation and friction on the journal center orbit, pad vibration response and minimum film thickness of water-lubricated TPJB were investigated. The influence rules of pivot radius ratio and pivot friction coefficient on bearing performance were revealed. The results show that pivot deformation could increase the system amplitude and minimum film thickness; pivot friction could reduce the system amplitude and has little effect on the minimum film thickness, and the effect is related to dynamic loads; increasing the pivot radius ratio and pivot friction coefficient could reduce the system amplitude; when the pivot radius ratio is 0.96~0.97 and the pivot friction coefficient is 0~0.15, the TPJB has higher load-carrying capacity. The research results provide reference value for the accurate modeling and optimal design of spherical-pivot TPJB.
Key words: tilting-pad journal bearing; pivot deformation; pivot friction; dynamic characteristic

关键词

可倾瓦轴承 / 支点变形 / 支点摩擦 / 动力学特性

Key words

tilting-pad journal bearing / pivot deformation / pivot friction / dynamic characteristic

引用本文

导出引用
金英泽1,袁小阳2. 考虑支点变形和摩擦的可倾瓦轴承动力学特性研究[J]. 振动与冲击, 2022, 41(20): 61-67
JIN Yingze1,YUAN Xiaoyang2. Dynamic characteristic analysis of tilting-pad journal bearings considering deformation and friction of pivot[J]. Journal of Vibration and Shock, 2022, 41(20): 61-67

参考文献

[1] 闫岗,金英泽,陈晖,等. 超导可倾瓦磁液复合轴承的动力学特性分析[J]. 西安交通大学学报,2020,54(11):65-73.
YAN Gang, JIN Yingze, CHEN Hui, et al. Analysis on the dynamic characteristics of superconducting tilting pad magnetic fluid composite bearings [J]. Journal of Xi’an Jiaotong University, 2020, 54(11): 65-73.
[2] JIN Y Z, CHEN F, XU J M, et al. Nonlinear dynamic analysis of low viscosity fluid-lubricated tilting-pad journal bearing for different design parameters [J]. Friction, 2020, 8(5): 930-944.
[3] 张楚,高庆水,邓小文. 汽轮机可倾瓦颤振引发低频振荡问题研究[J]. 振动与冲击,2014,33(11):61-64+94.
ZHANG Chu, GAO Qingshui, DENG Xiaowen. Subsynchronous vibration caused by pad fluttering of turbine tilting-pad bearings [J]. Journal of Vibration and Shock, 2014, 33(11): 61-64+94.
[4] WYGANT K D, FLACK R D, BARRETT L E. Influence of pad pivot friction on tilting-pad journal bearing measurements - Part I: Steady operating position [J]. Tribology Transactions, 1999, 42(1): 210-215.
[5] KIRK R G, REEDY S W. Evaluation of pivot stiffness for typical tilting-pad journal bearing designs [J]. Journal of Vibration Acoustics Stress and Reliability in Design-Transactions of the ASME, 1988, 110(2): 165-171.
[6] 李萌萌,王小静,蒋登峰,等. 可倾瓦轴承支点静刚度的有限元分析[J]. 润滑与密封,2015,40(8):109-111+132.
LI Mengmeng, WANG Xiaojing, JIANG Dengfeng, et al. Finite element analysis of stiffness of tilting pad bearing pivot [J]. Lubrication Engineering, 2015, 40(8): 109-111+132.
[7] 王占朝,刘莹,郭飞,等. 支点变形对水润滑可倾瓦推力轴承起动过程影响[J]. 摩擦学学报,2018,38(2):180-188.
WANG Zhanchao, LIU Ying, GUO Fei, et al. Influence of the pivot deformation on the water lubrication tilting-pad thrust bearing during Boot Process [J]. Tribology, 2018, 38(2): 180-188.
[8] MEHDI S M, JANG K E, KIM T H. Effects of pivot design on performance of tilting pad journal bearings [J]. Tribology International, 2018, 119: 175-189.
[9] SHI Z Y, JIN Y Z, YUAN X Y. Influence of pivot design on nonlinear dynamic analysis of vertical and horizontal rotors in tilting pad journal bearings [J]. Tribology International, 2019, 140: 105859.
[10] JIN Y Z, CHEN F, ZHANG F, et al. Nonlinear dynamic performance of tilting-pad journal bearing with adjustable elastic pivot design [J]. Tribology International, 2019, 136: 533-547.
[11] WYGANT K D, BARRETT L E, FLACK R D. Influence of pad pivot friction on tilting-pad journal bearing measurements - Part II: Dynamic coefficients [J]. Tribology Transactions, 1999, 42(1): 250-256.
[12] KIM S G, KIM K W. Influence of pad-pivot friction on tilting pad journal bearing [J]. Tribology International, 2008, 41(8): 694-703.
[13] KIM S, PALAZZOLO A B. Pad-pivot friction effect on nonlinear response of a rotor supported by tilting-pad journal bearings [J]. Journal of Tribology-Transactions of the ASME, 2019, 141(9): 091701.
[14] 党超,朱金婷,程联社,等. 支点摩擦力对可倾瓦径向滑动轴承润滑特性的影响[J]. 机械制造与自动化,2021,50(2):80-83+90.
DANG Chao, ZHU Jinting, CHENG Lianshe, et al. Influence of pivot friction on lubrication characteristics of tilting pad journal bearing [J]. Machine Building & Automation, 2021, 50(2): 80-83+90.
[15] TAYLOR C M, DOWSON D. Turbulent lubrication theory - Application to design [J]. Journal of Lubrication Technology-Transactions of the ASME, 1974, 96(1): 36-47.
[16] TANIGUCHI S, MAKINO T, TAKESHITA K, et al. A thermohydrodynamic analysis of large tilting-pad journal bearing in laminar and turbulent-flow regimes with mixing [J]. Journal of Tribology-Transactions of the ASME, 1990, 112(3): 542-548.
[17] HERTZ H. On the contact of elastic solids [J]. Journal Fur Die Reine Und Angewandte Mathematik, 1881, 92: 156-171.

PDF(2047 KB)

Accesses

Citation

Detail

段落导航
相关文章

/