高静压下长杆中轴向应力波衰减研究

卢勇, 张永民, 张少杰, 罗成, 邱爱慈

振动与冲击 ›› 2024, Vol. 43 ›› Issue (18) : 165-172.

PDF(2838 KB)
PDF(2838 KB)
振动与冲击 ›› 2024, Vol. 43 ›› Issue (18) : 165-172.
论文

高静压下长杆中轴向应力波衰减研究

  • 卢勇,张永民,张少杰,罗成,邱爱慈
作者信息 +

Attenuation of axial stress waves in a long rod under high hydrostatic pressure

  • LU Yong,ZHANG Yongmin,ZHANG Shaojie,LUO Cheng,QIU Aici
Author information +
文章历史 +

摘要

针对用于非常规页岩油开发的可控冲击波设备负载推送杆,本文提出了一种可用于高静压环境的内置吸收杆应力波衰减结构,基于LSDYAN与简化Johnson-Cook本构模型,开展了推送杆中应力波衰减规律的数值模拟研究。首先,基于实验数据对材料模型参数及数值算法的可靠性进行验证,在此基础上计算了不同外部环境、不同载荷参数及不同吸收杆参数对应力波衰减效果的影响。研究结果表明:外部是否存在静压对吸收杆的应力波吸收效果无显著影响,但静压会在空腔区造成部分应力集中,在50MPa外压力下内壁等效集中应力峰值可达100MPa;吸收杆对应力波能量的吸收效果取决于其脱离壁面前注入其中的能量;在载荷参数适配的条件下,通过串接多个吸收杆结构可以增加对应力波的衰减效果。研究结果可为水下高静压环境下的结构抗冲击防护设计提供指导与参考。

Abstract

Aiming at the load push rod of controllable shock wave equipment used in the development of unconventional shale oil, a stress wave attenuation structure with built-in absorbing rod that can be used in high hydrostatic pressure environment is proposed. Based on the LSDYAN software and the simplified Johnson-Cook material model, the attenuation of stress wave in push rod was numerically studied. First, the reliability of the material model parameters and numerical algorithm is verified based on the experimental data. On this basis, the influence of different external environments, different load parameters and different absorber rod parameters on the stress wave attenuation effect is analyzed. Numerical results demonstrate that whether there is hydrostatic pressure outside has no significant effect on the stress wave absorption effect of the absorbing rod. However, the hydrostatic pressure will cause partial stress concentration in the cavity area, and the peak value of the equivalent stress on the inner wall can reach 100MPa under the external pressure of 50MPa. The absorption effect of the absorbing rod on the stress wave energy depends on the energy injected into it before it breaks away from the push rod. When the load parameters are suitable, the attenuation effect on the stress wave can be increased by connecting multiple absorbing rod structures in series. The research results can provide guidance and reference for the impact protection design of structures in underwater high hydrostatic pressure environment.

关键词

高静水压 / 应力波衰减 / 有限元分析 / 抗冲击结构

Key words

high hydrostatic pressure / stress wave attenuation / finite element analysis;impact resistant structure

引用本文

导出引用
卢勇, 张永民, 张少杰, 罗成, 邱爱慈. 高静压下长杆中轴向应力波衰减研究[J]. 振动与冲击, 2024, 43(18): 165-172
LU Yong, ZHANG Yongmin, ZHANG Shaojie, LUO Cheng, QIU Aici. Attenuation of axial stress waves in a long rod under high hydrostatic pressure[J]. Journal of Vibration and Shock, 2024, 43(18): 165-172

参考文献

[1] 邱爱慈,张永民,蒯斌,et al.高功率脉冲技术在非常规天然气 开发中应用的设想[C]//第二届中国工程院/国家能源局能源论坛.2012:1112-1124. 
QIU Aici, ZHANG Yongmin, KUAI Bin, et al.Application of High Power Pulse Technology in UnConventional Gas Development[C]//Second Chinese Academy of Engineering National Energy Administration Energy Forum.2012.
[2] 张永民,邱爱慈,秦勇.电脉冲可控冲击波煤储层增透原理与工程实践[J].煤炭科学技术, 2017, 045(009):79-85. 
ZHANG Yongmin, QIU Aici, QIN Yong. Principle and engineering practices on coal reservoir permeability improved with electric pulse controllable shock waves.[J].Coal Science and  Technology,2017, 045(009):79-85.
[3] 赵树彬,张命俊,路远涛,等.可控冲击波增产技术在大庆油田的应用[J]. 石油管材与仪器,2022(05):76-80. 
ZHAO Shubin, ZHANG Mingjun, LU Yuantao, et al. Application of Controllable Shock Wave Stimulation Technology in Daqing Oilfield[J].PETROLEUM TUBULAR GOODS & INSTRUMENTS 2022(005):76-80.
[4] 孟子飞,徐思博,刘文韬,等.水下爆炸载荷作用下变截面结构中应力波的传播特性研究[J].舰船科学技术, 2019(13):12-19.
MENG Zifei, XU Sibo, LIU Wentao, et al. Research on propagation characteristics of stress wave in the variable cross-section structure subjected to underwater explosion load[J]. SHIP SCIENCE AND TECHNOLOGY, 2019(13):12-19.
[5] Kolsky,H.An Investigation of the Mechanical Properties of Materials at very High Rates of Loading[J].Proceedings of the Physical Society B, 1949, 62(11):676.
[6] 王礼立,胡时胜. 锥杆中应力波传播的放大特性[J]. 宁
波大学学报,1988,1( 1) : 69-78.
WANG Lili,HU Shisheng. The amplification of stress wavespropagated in a conical bar [J].Journal of Ningbo University,1988,1( 1) : 69-78.
[7] 曹增强,佘公藩,周听清.应力波在变截面杆中传播的数值分析[J].航空学报, 1998(06):71-75.
CAO Zengqiang,SHE Gongfan,ZHOU Tingqing. Numerical analysis of stress wwave propagation in a variable section bar[J]. Acta Aeronautica et Astronautica Sinica,1998,20( 6) :71-75.
[8] 刘孝敏,胡时胜.应力脉冲在变截面SHPB锥杆中的传播特性[J].爆炸与冲击, 2000, 20(2):5.
LIU Xiaomin,HU Shisheng. Wave propagation characteristics in cone bars used for variable cross-section SHPB[J].Explosion and Shock Waves,2000,20( 2) : 110-114.
[9] 姚磊,李永池.应力波在变截面体中的传播特性[J].爆炸与冲击,2007(04):345-351.
YAO Lei, LI Yongchi. The propagation characteristics of stress waves in a variable cross-section body[J]. Explosion and shock waves,2007(04):345-351.
[10] Wang X , Yue Z , Xu X ,et al.Ballistic impact response of elastomer-retrofitted corrugated core sandwich panels[J].International journal of impact engineering, 2023.
[11] Dolati S H , Rezaeepazhand J , Shariati M .Numerical simulation of hail impact response of hybrid corrugated core sandwich panels:[J].Journal of Reinforced Plastics and Composites, 2019, 38(14):643-657.
[12] 陈鹏.泡沫铝夹芯板力学特性研究[D].哈尔滨工程大学,2013.
CHENG Peng. Study on Mechanical Properties of Aluminum Foam Sandwich Panels[D]. Harbin Engineering University,2013. 
[13] 焦志刚、刘沫言、梁德刚、黄维平.复合壳体结构对冲击波衰减性能的影响[J].弹箭与制导学报, 2020, 40(4):103-109.
JIAO Zhigang, LIU Moyan, LIANG Degang, et al. Influence of Composite SHELL Structure on Shock Wave Attenuation Performance[J]. Journal of Projectiles, Rockets, Missilesand  Guidance,2020,40(4):103-109.
[14] 温庆阳,胡玮锋,金解放.高水压与高应力对岩石应力波传播速度的影响[J].矿业研究与开发,2022,42(12):127-133.
WEN Qinyang, HU Weifeng, JIN Jiefang. The influence of high water pressure and high stress on the propagation speed of rock stress waves[J]. MINING R&D,2022,42(12):127-133.
[15] 杨仲豪. 不同围压下岩石爆破数值模拟研究[D].北京理工大学,2020.
YANG Zhonghao. Numerical simulation research of rock blasting under different confining pressure [D]. Beijing Institute of Technology,2020.
[16] 陈敏.TC4钛合金力学性能测试及动态材料模型研究[D]. 南京:南京航空航天大学,2012.
CHEN Min. Research on Mechanical properties test and dynamic material model of Ti6Al4V titanium alloy[D]. Nanjing: Nanjing University of Aeronautics and Astronautics, 2012.
[17] 李建光,施琪,曹结东.Johnson-Cook本构方程的参数标定[J].兰州理工大学学报,2012,38(02):164-167.
LI Jianguang, SHI Qi, CAO Jiedong. Parameters calibration for Johnson-Cook constitutive equation[J]. Journal of Lanzhou University of Technology, 2012, 38(02):164-167.
[18] 李定远,朱志武,卢也森.冲击加载下42CrMo钢的动态力学性能及其本构关系[J].高压物理学报,2017,31(06):761-768.
LI Dingyuan, ZHU Zhiwu, LU Yesen. Mechanical Properties and Constitutive Relation for 42CrMo Steel under Impact Load[J]. CHINESE JOURNAL OF HIGH PRESSURE PHYSICS., 2012, 38(02):164-167.
[19] 孟龙,黄瑞源,王金相等.小当量梯恩梯水下爆炸气泡脉动的数值模拟[J].兵工学报,2020,41(S1):64-71.
MENG Long, HUANG Ruiyuan ,WANG Jinxiang, et al. Numerical Simulation of Bubble Pulsation of Small - scaled TNT in Underwater Explosion.[J]. ACTA ARMAMENTARII, 2020,41(S1):64-71.
[20] Lu Y, Zhang Y, Zhang S, et al. Stress measurement system for underwater electro-explosive platforms[J]. Review of Scientific Instruments, 2022, 93(10).
[21] Husain M, Yu J, Wu J. Comparisons of different approaches of modelling prestress in concrete members using LS-DYNA and its applications[J]. Concrete—Innovations in Materials, Design and Structures; The International Federation for Structural Concrete: Krakow, Poland, 2019: 812-819.
[22] YANG Jiacai, LIU Kewei, LI Xudong, et al. Stress initialization methods for dynamic numerical simulation of rock mass with high in-situ stress[J].Journal of Central South University, 2020, v.27(10):361-374.

PDF(2838 KB)

143

Accesses

0

Citation

Detail

段落导航
相关文章

/