基于EOE_LMD和阶次跟踪分析的变转速轴承故障诊断

张超,买买提热依木?阿布力孜

振动与冲击 ›› 2024, Vol. 43 ›› Issue (7) : 308-316.

PDF(1438 KB)
PDF(1438 KB)
振动与冲击 ›› 2024, Vol. 43 ›› Issue (7) : 308-316.
论文

基于EOE_LMD和阶次跟踪分析的变转速轴承故障诊断

  • 张超,买买提热依木?阿布力孜
作者信息 +

Fault diagnosis of variable rotating speed rolling bearing based on EOE_LMD and order tracking analysis

  • ZHANG Chao, MAIMAITIREYIMU Abulizi
Author information +
文章历史 +

摘要

振动信号分析是轴承故障诊断中的重要技术手段之一。变转速工况下的滚动轴承振动信号是典型的非平稳信号,并且在转频变化较小的工况中还存在噪声干扰的问题,使传统的时频分析技术难以应用。为解决该问题,提出了一种基于经验最优包络(empirical optimal envelope, EOE)的局部均值分解(local mean decomposition, LMD)和采用分段线性插值的计算阶次跟踪(computing order tracking, COT)算法相结合的故障诊断方法。首先,确定低通滤波器的截止频率和滤波阶数,对滚动轴承振动信号进行滤波,并对滤波后的包络信号进行COT,以获得角域平稳信号。然后,利用EOE_LMD对重采样后的平稳信号进行处理,得到若干乘积函数(product function, PF)分量。最后,通过计算各分量的信息熵和相关系数,选取合适的分量进行阶次分析,以判断变转速滚动轴承的故障类型。结果表明,所提出的方法可以消除转速波动对故障特征提取的影响,在不同转速变化条件下对滚动轴承具有良好的故障诊断能力。

Abstract

Vibration signal analysis is one of the important technical means in bearing fault diagnosis. The fault vibration signal of rolling bearing under the variable speed condition is a typical non-stationary signal, and there is also the problem of noise interference in the condition of small rotation frequency change, which makes the traditional time-frequency analysis technology difficult to apply. To solve this problem, a fault diagnosis method based on local mean decomposition (LMD) using empirical optimal envelope (EOE) and computing order tracking (COT) using piecewise linear interpolation was proposed. Firstly, the cut-off frequency and filtering order of the low-pass filter were determined to filter the vibration signal of the rolling bearing, and COT was performed on the filtered envelope signal to obtain the angular domain stationary envelope signal. Then, The local mean decomposition using empirical optimal envelope (EOE_LMD) was used to process the resampled stationary envelope signal to obtain several product function (PF) components. Finally, the information entropy and correlation coefficient of each component were calculated, and the appropriate component was selected for order analysis to judge the fault type of variable speed rolling bearing. The results show that the proposed method can eliminate the influence of speed fluctuation on fault feature extraction, and has good fault diagnosis ability for rolling bearings under different variable speed conditions.

关键词

滚动轴承 / 经验最优包络 / 局部均值分解 / 计算阶次跟踪 / 变转速工况

Key words

rolling bearing / empirical optimal envelope(EOE) / local mean decomposition (LMD) / computing order tracking (COT) / variable speed conditions

引用本文

导出引用
张超,买买提热依木?阿布力孜. 基于EOE_LMD和阶次跟踪分析的变转速轴承故障诊断[J]. 振动与冲击, 2024, 43(7): 308-316
ZHANG Chao, MAIMAITIREYIMU Abulizi. Fault diagnosis of variable rotating speed rolling bearing based on EOE_LMD and order tracking analysis[J]. Journal of Vibration and Shock, 2024, 43(7): 308-316

参考文献

[1] ZHANG C, WANG R, YU L, et al. Order domain beamforming for the acoustic localization of rotating machinery under variable speed working conditions [J]. Applied Acoustics, 2023, 205: 109290. [2] 宫涛, 杨建华, 单振, 等. 强噪声背景与变转速工况条件下滚动轴承故障诊断研究 [J]. 工矿自动化, 2021, 47(07): 63-71. GONG Tao, YANG Jianhua, SHAN Zhen, et al. Research on Rolling bearing Fault diagnosis under strong noise background and variable speed working condition [J]. Journal of Mine Automation, 2021, 47(07): 63-71. [3] ZHANG K, MA C, XU Y, et al. Feature extraction method based on adaptive and concise empirical wavelet transform and its applications in bearing fault diagnosis [J]. Measurement, 2021, 172: 108976. [4] 刘东东, 程卫东, 温伟刚. 广义解调算法中能量因子的引入与配置原理的研究 [J]. 振动工程学报, 2020, 33(01): 213-218. LIU Dongdong, CHENG Weidong, WEN Weigang. Introduced energy factor to generalized demodulation and its configuration [J]. Journal of Vibration Engineering, 2020, 33(01): 213-218. [5] 肖飞, 张宏立, 马萍, 等. 基于多时频曲线提取广义特征的变转速轴承故障诊断 [J]. 振动与冲击, 2022, 41(13): 152-159+188. XIAO Fei, ZHANG Hongli, MA Ping, et al. Fault diagnosis of variable rotating speed rolling bearing using generalized features based on MTFCE [J]. Journal of Vibration and Shock, 2022, 41(13): 152-159+188. [6] SUN Y, LI S, WANG X. Bearing fault diagnosis based on emd and improved chebyshev distance in sdp image [J]. Measurement, 2021, 176: 109100. [7] CHENG Y, WANG Z, CHEN B, et al. An improved complementary ensemble empirical mode decomposition with adaptive noise and its application to rolling element bearing fault diagnosis [J]. ISA Transactions, 2019, 91: 218-234. [8] 赵德尊, 李建勇, 程卫东. 变转速及齿轮噪源干扰下基于IDMM与EMD的滚动轴承故障诊断方法 [J]. 振动与冲击, 2016, 35(10): 101-107+119. ZHAO Dezun, LI Jianyong, CHENG Weidong. Method for rolling element bearing fault diagnosis based on IDMM and EMD under time-varying rotational speed and gear noise [J]. Journal of Vibration and Shock, 2016, 35(10): 101-107+119. [9] SMITH J S. The local mean decomposition and its application to EEG perception data [J]. Journal of The Royal Society Interface, 2005, 2(5): 443-454. [10] 张亢, 程军圣. 基于LMD和阶次跟踪分析的滚动轴承故障诊断 [J]. 振动.测试与诊断, 2016, 36(03): 586-591+611. ZHANG Kang, CHENG Junsheng. Rolling bearing fault diagnosis based on LMD and order tracking analysis [J]. Journal of Vibration, Measurement & Diagnosis, 2016, 36(03): 586-591+611. [11] JIA L S, ZHANG Q, ZHENG X, et al. The empirical optimal envelope and its application to local mean decomposition [J]. Digital Signal Processing, 2019, 87: 166-177. [12] 明安波, 张炜, 秦朝烨, 等. 改进的计算阶比跟踪及其应用 [J]. 振动与冲击, 2015, 34(04): 40-47. MING Anbo, ZHANG Wei, QIN Chaoye, et al. Improved computing order tracking method and its applications [J]. Journal of Vibration and Shock, 2015, 34(04): 40-47. [13] XU L, DING K, HE G, et al. A novel tacholess order tracking method for gearbox vibration signal based on extremums search of gearmesh harmonic [J]. Mechanical Systems and Signal Processing, 2023, 189: 110070. [14] DUAN R, LIAO Y, YANG L. Adaptive tacholess order tracking method based on generalized linear chirplet transform and its application for bearing fault diagnosis [J]. ISA Transactions, 2022, 127: 324-341. [15] LI Y, DING K, HE G, et al. Non-stationary vibration feature extraction method based on sparse decomposition and order tracking for gearbox fault diagnosis [J]. Measurement, 2018, 124: 453-469. [16] 郭瑜, 秦树人, 汤宝平, 等. 基于瞬时频率估计的旋转机械阶比跟踪 [J]. 机械工程学报, 2003, 39(03): 32-36. GUO Yu, QIN Shuren, TANG Baoping, et al. Order tracking of rotating machinery based on instantaneous frequency estimation [J]. Journal of Mechanical Engineering, 2003, 39(03): 32-36. [17] 蔺梦雄, 张向慧, 姚良博, 等. 阶次跟踪分析方法在机器人用精密减速器摆动疲劳试验故障诊断中的应用 [J]. 机械传动, 2022, 46(10): 156-162. LIN Mengxiong, ZHANG Xianghui, YAO Liangbo, et al. Application of order tracking analysis method in fault diagnosis of swing fatigue tests of precision reducers for robots [J]. Journal of Mechanical Transmission, 2022, 46(10): 156-162. [18] FENG K, JI J C, WANG K, et al. A novel order spectrum-based vold-kalman filter bandwidth selection scheme for fault diagnosis of gearbox in offshore wind turbines [J]. Ocean Engineering, 2022, 266: 112920. [19] 丛华, 吴广平, 饶国强, 等. 计算阶次分析中避免阶次混叠的滤波定阶方法及其应用[J]. 振动与冲击, 2012, 31(12): 42-44+85. Cong Hua, WU Guangping, RAO Guoqiang. A method to avoid order aliasing in COT based on filtering [J]. Journal of Vibration and Shock, 2012, 31(12): 42-44+85. [20] HUANG H, BADDOUR N. Bearing vibration data collected under time-varying rotational speed conditions [J]. Data in Brief, 2018, 21: 1745-1749.

PDF(1438 KB)

Accesses

Citation

Detail

段落导航
相关文章

/