基于非接触转子振动测试的转子行波分析

PDF(1388 KB)

振动与冲击 ›› 2019, Vol. 38 ›› Issue (20) : 25-30.

论文

基于非接触转子振动测试的转子行波分析

张岩松，张东明，邱大明，李成刚，刘洋

作者信息 +

Rotor blades travelling-wave analysis based on non-contact vibration measurement

ZHANG Yansong, ZHANG Dongming, QIU Daming, LI Chenggang, LIU Yang

Author information +

文章历史 +

摘要

在非接触转子振动测试系统中，以离散化傅里叶变换为理论基础，建立了对航空发动机整级转子叶片振动频率的分析方法，得到整级转子叶片在静坐标系下的振动频率，结合相同试验条件下应变计对转子叶片动态频率的测试结果，实现了航空发动机转子的行波振动分析。在某压气机试验中，整级转子叶片在转速12343rpm时，静坐标系下的振动频率为1752.7Hz，转子坐标系下的振动频率为926.4Hz，通过对测试结果的分析，得到了压气机转子的4节径前行波振动特性，结合压气机转子振动的坎贝尔图得到频率裕度和转速裕度。

Abstract

This paper describes application of a non-contact vibration measurement and analysis method, which is based on discrete Fourier transform analysis of the vibration frequency of engine all-blades in a stage.By comparing the stage vibration frequency of all-blades in the stationary reference frame with the vibrations frequency in the rotating reference frame, the travelling wave structures of the engine rotor were analyzed in detail.According to the measurement of blades vibration in the compressor experimental, the vibration frequency is 1752.7 Hz in the stationary reference frame and 926.4 Hz in the rotating reference frame respectively at the speed of 12343 r/min, forming a four-nodal-diameter forward travelling wave.The frequency and speed margin were obtained by further connecting the travelling wave with the Campbell diagram of compressor rotor vibration.

导出引用

张岩松，张东明，邱大明，李成刚，刘洋. 基于非接触转子振动测试的转子行波分析[J]. 振动与冲击, 2019, 38(20): 25-30

ZHANG Yansong, ZHANG Dongming, QIU Daming, LI Chenggang, LIU Yang. Rotor blades travelling-wave analysis based on non-contact vibration measurement[J]. Journal of Vibration and Shock, 2019, 38(20): 25-30

参考文献

[1] Nelson F C. Rotor Dynamics without Equations[J] International Journal of COMADEM, 2007, 10(3):2-10.
[2] 晏砺堂，朱梓根，李其汉，等.高速旋转机械振动[M]. 北京：国防工业出版社，1994.
[3] 吕文林. 航空发动机强度计算[M]. 北京：国防工业出版社，1988.
[4] 晏砺堂，任光明.齿轮断块失效原因再探[J]. 航空动力学报，1999,14(4):337-343.
Yan Litang, Ren Guangming. A study on cause for some gear failures[J]. Journal of Aerospace Power, 1999, 14(4):337-343.
[5] 王桂华,李琳. 旋转脉动激励下壳体的行波振动[J]. 航空发动机，1999，1:30-33.
WANG Guihua, LI Lin. Traveling wave vibration of shell under rotating impulse load[J]. Journal of Aero engine, 1999, 1:30-33.
[6] 王桂华，李琳. 航空发动机风扇机匣行波振动的分析方法[J]. 航空动力学报，2000，15(2):183-186.
WANG Guihua, LI Lin. Method for traveling wave vibration analysis of fan casing in aero-engine[J]. Journal of Aerospace Power, 2000，15(2):183-186.
[7] 曹航，朱梓根. 转动壳体行波振动的有限元分析方法[J]. 航空动力学报，2002，17(2):222-225.
Cao Hang, Zhu Zigen. Traveling-wave vibration of rotating shells by finite element method[J]. Journal of Aerospace Power, 2002，17(2):222-225.
[8] 洪杰，郭宝亭，朱梓根. 高速转动壳体行波振动实验研究[J]. 航空动力学报，1988,13(4):390-394.
HONG Jie, GUO Baoting, ZHU Zigeng. Experimental investigation on travelling wave of high-speed rotating shell[J]. Journal of Aerospace Power,1988,13(4):390-394.
[9] 王能茂，王延荣.转动薄壁圆柱筒振动特性：有限元法与解析解的对比[J].航空动力学报，2017，32（3）：689-696.
WANG Nengmao, WANG Yanrong. Vibration characteristics of rotating thin-walled cylindrical shell: comparison of finite element method with analytical solution[J]. Journal of Aerospace Power, 2017, 32(3):689-696.
[10] 魏武国. 某航空发动机高压压气机盘的振动特性分析[J] 科学技术与工程,2014,14(13):286-290.
WEI Wuguo. Vibration characteristics analysis of high-pressure compressor disk from an aero engine[J] Science Technology and Engineering, 2014,14(13):286-290.
[11] Watkins W B, Robinson W W, Chi R M. Noncontact Engine Blade Vibration Measurements and Analysis [C] AIAA/SAE/ASME/ASEE 23rd Joint Propulsion Conference, San Diego, CA, AIAA-85-1473.
[12] Heath S, Imregun M. A review of analysis techniques for blade tip-timing measurements [R] ASME 97-GT-213, 1997.
[13] Zielinski M, Ziller G. Noncontact vibration measurements on compressor rotor blades[J] Meas. Sci. Technol. 2000,11:847-856.
[14] 李勇, 胡伟, 王德友，等. 非接触式转子叶片振动测试技术应用研究[J]. 航空动力学报，2008，23(1):21-25.
LI Yong, HU Wei, WANG Deyou, et al. Investigation and application of non-contact rotor blade vibration measurement technique[J]. Journal of Aerospace Power, 2008,23(1):21-25.
[15] 胡伟，王磊，米江. 基于叶尖定时技术分析叶片非整阶次振动[J]. 航空科学技术, 2011,6:55-59.
HU Wei, WANG Lei, MI Jiang. Analysis of Blade Asynchronous Vibrations by Blade Tip Timing[J]. Aeronautical Science & Technology, 2011,6:55-59.
[16] Kharyton V, Gibert C, Blanc L, et al. Elements of dynamic characterization of a bladed disk by using the tip-timing method under vacuum conditions[R]. ASME GT2011-46435, 2011.
[17] Bendali Salhi, Joseph Lardies, Marc Berthillie, et al. Modal parameter identification of mistuned bladed disks using tip timing data [J]. Journal of Sound and Vibration, 2008,314:855-906.
[18] 《数学手册》编写组. 数学手册[M]. 北京：人民教育出版社，1979.
[19] Castanier M P, Pierre C. Modeling and analysis of mistuned bladed disk vibration: status and emerging directions[J]. Journal of Propulsion and Power, 2006,22(2):384-396.
[20] 张岩松，邱大明，王洪斌.非接触转子振动位移采集系统测试误差[J].航空动力学报,2018.33(2):299-304.
ZHANG Yansong, QIU Daming, WANG Hongbin. Measurement error of non-contact rotor vibraiton displacement measurement system[J]. Journal of Aerospace Power, 2018,33(2):299-304.
[21] Gallego-Garrido J， Dimitriadis G， Carrington I B， et al. A class of methods for the analysis of blade tip timing data from bladed assemblies undergoing simultaneous resonances - part II: experimental validation[EB/OL]. http://dx.doi.org/10.1155/2007/73624, 2007.