滚珠丝杠式燃气舵结构仿真与运动控制

刘静怡1,郑健1,魏岩淞2

振动与冲击 ›› 2023, Vol. 42 ›› Issue (16) : 66-71.

PDF(1821 KB)
PDF(1821 KB)
振动与冲击 ›› 2023, Vol. 42 ›› Issue (16) : 66-71.
论文

滚珠丝杠式燃气舵结构仿真与运动控制

  • 刘静怡1,郑健1,魏岩淞2
作者信息 +

Structural simulation and motion control of a ball screw gas rudder

  • LIU Jingyi1,ZHENG Jian1,WEI Yansong2
Author information +
文章历史 +

摘要

针对燃气舵在启动瞬间会产生很大的冲击力,采用ADAMS和ANSYS对传动机构进行了动力学分析和有限元分析的联合仿真,得到了变负载下相邻零件的冲击力,并分析了危险零件的瞬态动力响应。分析结果表明,在一定范围内,冲击力随响应时间的增加响应速度变慢,最大值和最小值分别基本保持一致。建立了燃气舵系统的数学模型,在MATLAB Simulink中进行了系统的PID控制仿真分析,并基于仿真结果进行了单片舵系统的运动控制实验。实验结果表明,该控制平台能达到良好的控制效果。

Abstract

In view of the large impact force of the gas rudder at the starting moment, the joint simulation of dynamic analysis and finite element analysis of the transmission mechanism was carried out by ADAMS and ANSYS, the impact force of adjacent parts under variable load was obtained, and the transient dynamic response of the dangerous part was analyzed. The results show that within a certain range, the response speed of the impact force becomes slower with the increasing response time, and the maximum and minimum values are basically the same. The mathematical model of the gas rudder system was established, the PID control simulation analysis of the system was carried out in MATLAB Simulink, and the motion control experiment of the monolithic rudder system was carried out based on the simulation results. The experimental results show that the control platform can achieve good control effect.

关键词

燃气舵 / 动力学分析 / 瞬态动力学响应 / 建模 / PID

Key words

Gas rudder / Dynamic analysis / Transient dynamic response / Modeling / PID

引用本文

导出引用
刘静怡1,郑健1,魏岩淞2. 滚珠丝杠式燃气舵结构仿真与运动控制[J]. 振动与冲击, 2023, 42(16): 66-71
LIU Jingyi1,ZHENG Jian1,WEI Yansong2. Structural simulation and motion control of a ball screw gas rudder[J]. Journal of Vibration and Shock, 2023, 42(16): 66-71

参考文献

[1]  卜庆伟,陈雄,崔二伟.推力矢量发动机燃气舵系统设计与分析[J].科学技术与工程,2017,17(33):182-187.
Bu Qingwei, Chen Xiong, Cui Erwei. Design and analysis on jet vane system of thrust-vector motor[J]. Science Technology and Engineering, 2017, 17(33):182-187.
[2]  Yu Bing, and Shu Wenjun. A Novel Control Approach for a Thrust Vector System with an Electromechanical Actuator[J]. IEEE Access, 2017:15542-15550.
[3]  邱吉宝,张正平,等.结构动力学及其在航天工程中的应用[M].合肥:中国科学技术大学出版社, 2015.
[4]  倪迎鸽,侯赤,万小朋,等.机翼折叠运动的瞬态动力学响应分析[J].西北工业大学学报,2016,34(03):418-423.
Ni Yingge, Hou Chi, Wan Xiaopeng, et al. Transient Dynamic Response Analysis of a Wing in the Folding Motion[J]. Journal of Northwestern Polytechnical University, 2016, 34(03):418-423.
[5]  李彪,张世隆,吴君,等.微小卫星解锁机构冲击动力学特性研究[J].机械强度,2018,40(05):1258-1262.
Li Biao, Zhang Shilong, Wu Jun, et al. The Impact Dynamic Characteristics of Release Device for Micro-satellite[J]. Journal of Mechanical Strength, 2018,40(05):1258-1262.
[6]  周军,高跃飞,王登,等.基于ADAMS的火炮发射动力学仿真研究[J].振动与冲击,2020,39(23):135-140.
Zhou Jun, Gao Yuefei, Wang Deng, et al. Artillery launch dynamic simulation based on ADAMS[J]. Journal of Vibration and Shock, 2020,39(23):135-140.
[7]  徐梦圆,林友志,章心怡.采用丝杠传动的电动舵机运动学分析[J].海军航空工程学院学报,2018,33(03):297-301.
Xu Mengyuan, Lin Youzhi, Zhang Xinyi. Kinematics Analysis of Electric Servo System Driving by Screw[J]. Journal of Naval Aeronautical and Astronautical University, 2018,33(03):297-301.
[8]  李增刚. ADAMS入门详解与实例[M]. 北京:国防工业出版社, 2014.
[9]  黄剑锋,余涛,陈江义.刚体碰撞的Hertz接触力模型比较分析[J].机械设计与制造,2017(08):28-30.
Huang Jianfeng,Yu Tao,Chen Jiangyi. Comparison and Analysis of Hertz Contact Force Models for Collision of Rigid Bodies[J]. Machinery Design & Manufacture, 2017(08):28-30.
[10] 钱杏芳, 林瑞雄, 赵亚男. 导弹飞行力学[M]. 北京理工大学出版社, 2013.
[11] 倪博溢,萧德云.MATLAB环境下的系统辨识仿真工具箱[J].系统仿真学报,2006(06):1493-1496.
Ni Boyi, Xiao Deyun. System Identification and Simulation Toolbox under MATLAB Environment[J]. Journal of System Simulation, 2006(06):1493-1496.

PDF(1821 KB)

Accesses

Citation

Detail

段落导航
相关文章

/