倒频谱编辑法在含转子结构运行模态参数辨识中的应用

陈伟,顾晓华,张永强

振动与冲击 ›› 2023, Vol. 42 ›› Issue (18) : 268-275.

PDF(1853 KB)
PDF(1853 KB)
振动与冲击 ›› 2023, Vol. 42 ›› Issue (18) : 268-275.
论文

倒频谱编辑法在含转子结构运行模态参数辨识中的应用

  • 陈伟,顾晓华,张永强
作者信息 +

Cepstrum editing method used in operational modal analysis of rotor structures

  • CHEN Wei, GU Xiaohua, ZHANG Yongqiang
Author information +
文章历史 +

摘要

工况模态分析或称运行模态分析,通常假设结构所受载荷为白噪声,响应谱中峰值皆由结构模态导致。然而机械系统通常含有转子部件,在运行状态下测量响应中周期性谐波或其倍频响应占据主导,加剧了工况下模态参数辨识的难度。针对上述问题,该文提出了基于倒频谱编辑的工况模态参数辨识方法,识别测量响应中的谐波及其倍频响应并在参数辨识前去除其对模态参数提取的影响。所提方法适用于多谐波激励、谐波频率与结构模态频率重叠、慢变谐波等情况,通过三自由系统算例、自由边界钢梁试验和某型航空发动机试车实测数据验证了方法的可靠性。

Abstract

Operational modal analysis technique, or output only modal analysis, commonly holds the assumption that the excitations acting on the structure are white noise, and therefore the peaks in the response spectrum all correspond to the modes of the structure. However, mechanical systems usually have rotor parts, and the periodic harmonics and their super-harmonics will dominate the measured responses at the operating states, which adds the difficulty in the identification of modal parameters. To solve the aforementioned problem, the paper proposes a modal parameter identification method based on cepstrum editing, which is able to identify the harmonic frequency and remove the effect of harmonics on modal parameter identification. The proposed method can handle the cases of multiple harmonics, the overlapping of the harmonic frequency and the modal frequency, slow-varying harmonics, etc. The proposed method is verified through a three degree-of-freedom system, a free-free steel beam, and the measured responses of an aircraft engine.

关键词

工况模态分析 / 转子结构 / 谐波 / 倒频谱 / 参数辨识

Key words

operational modal analysis / rotor structures / harmonics / cepstrum editing / parameter identification

引用本文

导出引用
陈伟,顾晓华,张永强. 倒频谱编辑法在含转子结构运行模态参数辨识中的应用[J]. 振动与冲击, 2023, 42(18): 268-275
CHEN Wei, GU Xiaohua, ZHANG Yongqiang. Cepstrum editing method used in operational modal analysis of rotor structures[J]. Journal of Vibration and Shock, 2023, 42(18): 268-275

参考文献

[1] JAMES G H, CARNE T G, LAUFFER J P. The natural excitation technique (next) for modal parameter extraction from operating structures [J]. Modal Analysis-the International Journal of Analytical and Experimental Modal Analysis, 1995, 10(4): 260-77.
[2] 续秀忠, 华宏星, 陈兆能. 基于环境激励的模态参数辨识方法综述[J].振动与冲击,2002,21(3):1-5.
XU Xiu-zhong, HUA Hong-xing, CHEN Zhao-neng. Review of Modal Identification Method Based on Ambient Excitation [J]. Journal of Vibration and Shock, 2002, 21(3):1-5.
[3] 张济淳, 宋汉文. 环境激励下基于相关函数的脉冲响应函数重构[J]. 振动与冲击, 2020, 39(10).
Zhang Ji-chun, SONG Han-wen. Reconstruction of impulse response function based on correlation function under ambient excitation [J]. Journal of Vibration and Shock, 2020, 39(10).
[4] 廖明夫, 于潇, 王四季等. 双转子系统的振动[J]. 机械科学与技术, 2013, 32(4).
LIAO Ming-fu, YU Xiao, WANG Si-ji, et al. The Vibration Features of a Twin Spool Rotor System [J]. Mechanical Science and Technology for Aerospace Engineering, 2013, 32(4).
[5] 于亮亮,宋汉文. 激励中含有谐波成分时的工况模态参数辨识[J]. 振动工程学报, 2018, 31(01).
YU Liang-liang, SONG Han-wen. Operational modal analysis in the presence of harmonic excitation [J]. Journal of Vibration Engineering, 2018, 31(01).
[6] 张义民,李鹤,闻邦椿. 运行模态分析中谐波模态识别方法研究及应用[J]. 振动,测试与诊断, 2008, 28 (3).
ZHANG Yi-min, LI He, WEN Bang-chun. Harmonic Mode Identification in the Operational Modal Analysis and Its Application[J]. Journal of Vibration Measurement & Diagnosis, 2008, 28 (3).
[7] 夏遵平,王彤. 基于谱峭度的谐波模态检测方法[J]. 工程力学, 2013, 30(12).
XIA Zun-ping, WANG Tong. Detection Of Harmonic Modes With Spectral Kurtosis[J]. Engineering Mechanics, 2013, 30(12).
[8] PINTELON R., PEETERS B., GUILLAUME P. Continuous-time operational modal analysis in the presence of harmonic disturbances [J]. Mechanical Systems and Signal Processing, 2008, 22(5): 1017-35.
[9] CHEN W, JIN M, HUANG J, et al. A method to distinguish harmonic frequencies and remove the harmonic effect in operational modal analysis of rotating structures [J]. Mechanical Systems and Signal Processing, 2021,161.
[10] BOGERT B. P., HEALY M. J., TUKEY J. W. The quefrency alanysis of time series for echoes: cepstrum, pseudo-autocovariance, cross-cepstrum and saphe cracking [M]. Proceedings of the Symposium on Time Series Analysis. 1963.
[11] RANDALL R. B. A history of cepstrum analysis and its application to mechanical problems [J]. Mechanical Systems and Signal Processing, 2017, 97(3).
[12] 陈伟, 宋汉文. 非自伴随动力学系统的工况模态分析[J]. 振动工程学报, 2018, 31(5).
CHEN Wei, SONG Han-wen. Operational modal analysis of non-self-adjoint dynamic system [J]. Journal of Vibration Engineering, 2018, 31(5).
[13] 于亮亮, 宋汉文. 环境激励下脉冲响应函数与相关函数的关系[J]. 噪声与振动控制, 2017, 37(03): 14-18.
YU Liang-liang, SONG Han-wen. Discussion on the Relation between Correlation Functions and Impulse Response Functions under Ambient Excitation [J]. Noise and Vibration Control, 2017, 37(03):14-18.

PDF(1853 KB)

Accesses

Citation

Detail

段落导航
相关文章

/