Dynamic modeling for inter-shaft bearings with surface local defect considering elasto-hydro lubrication effects#br#

PDF(1118 KB)

Journal of Vibration and Shock ›› 2019, Vol. 38 ›› Issue (5) : 80-85.

TIAN Jing1, AI Yanting2, ZHAO Ming1, SUN Dan2, ZHANG Fengling2

Author information +

History +

Abstract

Inter-shaft bearings of an aero-engine are located at the place between its high pressure rotor and low pressure one. The inner and outer rings of inter-shaft bearing rotate in the same direction or opposite one with high and low pressure rotors, and their relative rotating speed is high and lubrication condition is bad to cause frequent occurrence of faults. Here, aiming at vibration fault diagnosis of inter-shaft bearings with surface local defect, a dynamic modeling method for them was proposed considering effects of elasto-hydro dynamic lubrication and time-varying displacement excitation. A dual-rotor test platform was used to conduct analog tests for outer ring fault of inter-shaft bearing, and vibration signals were collected and analyzed. Comparing the numerical simulation results of the established dynamic model and the test ones, the correctness of the established dynamic model was verified. Based on the established dynamic model, vibration responses of inter-shaft bearings with and without lubrication under different defect sizes were numerically simulated. The results showed that the model built here can be used to correctly simulate vibration responses of inter-shaft bearings under different conditions and different defect sizes, and analyze the fault mechanism of inter-shaft bearings.

Key words

inter-shaft bearing / elasto-hydro dynamic / local defect / time-varying displacement / dynamic model

Cite this article

EndNote

Ris (Procite)

Bibtex

Download Citations

TIAN Jing1, AI Yanting2, ZHAO Ming1, SUN Dan2, ZHANG Fengling2. Dynamic modeling for inter-shaft bearings with surface local defect considering elasto-hydro lubrication effects#br#[J]. Journal of Vibration and Shock, 2019, 38(5): 80-85

References

[1] 廖明夫，马振国，刘永泉，等. 航空发动机中介轴承的故障特征与诊断方法[J]. 航空动力学报. 2013, 28(12): 2752-2758.
LIAO Mingfu, MA Zhenguo, LIU Yongquan. et al. The Fault characteristics and diagnosis method of inter-shaft bearing in aero-engine[J].Journal of Aerospace Power. 2013, 28(12): 2752-2758.
[2] 艾延廷，陈潮龙，田晶，等. 基于信息熵距和 FSVM 隶属度的转子振动状态评估方法[J]. 推进技术. 2013(11): 1543-1548.
AI Yanting, CHEN Chaolong, TIAN Jing. et al. Studies on Assessing Method of Rotor Vibration State Based on Information Entropy Distance and FSVM Membership[J]. Journal of Propulsion Technology. 2013(11): 1543-1548.
[3] C.S. Sunnersjö. Varying compliance vibrations of rolling bearings[J]. Journal of Sound & Vibration, 1978, 58(58):363-373.
[4] P. K. Gupta. Dynamics of Rolling-Element Bearings—Part I,II,III, and IV [J]. Journal of Tribology, 1979, 101(3):311-326.
[5]Gupta P K. On the Geometrical Imperfections in Cylindrical Roller Bearings[J]. Journal of Tribology, 1988, 110(1):13-18.
[6] Mcfadden P D, Smith J D. Model for the vibration produced by a single point defect in a rolling element bearing[J]. Journal of Sound & Vibration, 1984, 96(1):69-82.
[7] Tandon N, Choudhury A. AN ANALYTICAL MODEL FOR THE PREDICTION OF THE VIBRATION RESPONSE OF ROLLING ELEMENT BEARINGS DUE TO A LOCALIZED DEFECT[J]. Journal of Sound & Vibration, 1997, 205(3):275-292.
[8] Kulkarni P G,Sahasrabudhe A D. A Dynamic Model of Ball Bearing for Simulating Localized Defects On Outer Race Using Cubic Hermite Spline[J]. Journal of Mechanical Science and Technology, 2014, 28(9): 3433-3442.
[9] 刘静, 邵毅敏, 秦晓猛,等. 基于非理想Hertz线接触特性的圆柱滚子轴承局部故障动力学建模[J]. 机械工程学报, 2014, 50(1):91-97.
Liu J, Shao Y, Qin X, et al. Dynamic Modeling on Localized Defect of Cylindrical Roller Bearing Based on Non-Hertz Line Contact Characteristics[J]. Journal of Mechanical Engineering, 2014, 50(1):91.
[10] 徐可君, 董芳华, 秦海勤,等. 有局部缺陷的滚动体中介轴承动力学建模及仿真研究[J]. 振动与冲击, 2016, 35(2):104-109..
KJ Xu，FH Dong，HQ Qin. Dynamics modeling and simulation on inter-shaft bearing with local defect rolling element [J]. Journal of Vibration and shock. 2016, 35(2):104-109.
[11] Patel V N, Tandon N, Pandey R K. Vibration Studies of Dynamically Loaded Deep Groove Ball Bearings in Presence of Local Defects on Races[J]. Procedia Engineering, 2013, 64(64):1582-1591.
[12] Patil M S, Mathew J, Rajendrakumar P Ket al. A Theoretical Model to Predict the Effect of Localized Defect On Vibrations Associated with Ball Bearing[J]. International Journal of Mechanical Sciences, 2010, 52(9): 1193-1201.
[13] Harris T A, Park U, Kotzalas M N, et al. Rolling Bearing Analysis, Fifth Edition - 2 Volume. Crc Press, 2006.
[14] 吴昊，王建文，安琦．圆柱滚子轴承阻尼的计算方法［J］．
轴承,2008(9):1-5．
Hao W U, Wang J W, Qi A N. Calculating Method for Damping of Cylindrical Roller Bearings[J]. Bearing, 2008(9):1-5．
[15] Lubrecht A A, Venner C H, Colin F. Film thickness calculation in elasto-hydrodynamic lubricated line and elliptical contacts: The Dowson, Higginson, Hamrock contribution[J]. ARCHIVE Proceedings of the Institution of Mechanical Engineers Part J Journal of Engineering Tribology 2009, 223(3):511-515.
[16] 唐云冰, 高德平, 罗贵火. 航空发动机滚动轴承的载荷分布研究[J]. 航空学报, 2006, 27(6):1117-1121.
Tang Y B, Gao D P, Luo G H. Research on the Load Distribution in Aeroengine Ball Bearings[J]. Acta Aeronautica Et Astronautica Sinica, 2006, 27(6):1117-1121.
[17] 麻胜兰, 姜绍飞, 陈志刚. 基于IMPSCO和改进Newmark-β算法的结构系统及激励辨识研究[J]. 振动与冲击, 2017(15):22-28.
SL Ma, SF Jiang, ZG Chen. Identification of a structural system and its excitation based on IMPSCO and modified Newmark-β algorithm. [J]. Journal of Vibration and shock. 2017(15):22-28.